Remove All Ads from XDA

Butterfly J SD conversion?

37 posts
Thanks Meter: 5
By d3fiance, Member on 1st June 2014, 04:49 AM
Post Reply Email Thread
Has any one done this yet? The parts are available here:

Top motherboard piece for the sd/sim card tray

The back cover, since the phone will be slightly thicker:

After looking at the DNA's motherboard piece and the ribbon cables, it looks to be a direct swap. I'm assuming the issue will be the drivers. I wonder if anyone is willing to work on a port from the Butterfly J.

I thinking about pulling the trigger on this, but without drivers I may stuck dead in the water, unless this actually catches interest.

2nd June 2014, 06:00 AM |#2  
eriknors's Avatar
Senior Member
Thanks Meter: 328
What drivers would be needed and just because it would fit doesn't mean it would work. I think the only driver that would be needed would be one for external sd support. Everything else is exactly the same

sent from my DNA
3rd June 2014, 05:33 PM |#3  
theseabass's Avatar
Senior Member
Thanks Meter: 62
Since the cover is thicker, wouldn't that cause the camera and flash to not make contact with the lense and housing? Wouldn't this also break contact with all antennas on the back housing due to it no longer being fit to the rear of the phone? Just my curiosities here.

Sent from my HTC6435LVW using XDA Premium 4 mobile app
Post Reply Subscribe to Thread

Guest Quick Reply (no urls or BBcode)
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes