Remove All Ads from XDA
Honor 9 Lite

Body Glove case modded for 2150

11 posts
Thanks Meter: 2
By BigBuddha, Junior Member on 8th September 2010, 07:25 PM
Post Reply Email Thread
Nothing really new here. I've simply modded the Body Glove case to fit the 2150 battery as others have done with other cases and wanted to show the results. The interesting thing about this case is that it's so beefy to begin with that the battery barely sticks out the back. The sides are also very well protected. The only real difficulty with this mod was dremeling the inside of the case for the hump on the camera cover.
Attached Thumbnails
Click image for larger version

Name:	Dinc01.jpg
Views:	238
Size:	25.1 KB
ID:	397416   Click image for larger version

Name:	Dinc02.jpg
Views:	305
Size:	28.7 KB
ID:	397417   Click image for larger version

Name:	Dinc03.jpg
Views:	224
Size:	22.7 KB
ID:	397418   Click image for larger version

Name:	Dinc04.jpg
Views:	217
Size:	30.0 KB
ID:	397419  
11th September 2010, 12:13 PM |#2  
chingy51o's Avatar
Senior Member
Flag Cali
Thanks Meter: 1,463
Donate to Me
What did you use to cut the case?

Sent from my HTC Droid Incredible
14th September 2010, 04:09 PM |#3  
OP Junior Member
Thanks Meter: 2
I used a dremel hard abrasive cutoff wheel. The edge of the wheel for cutting and the face of the wheel for creating the pocket for the camera bumpout. It needs a little patience, but wasn't too bad. I did nick the case a couple of times when I wasn't paying attention, so be careful.
21st September 2010, 03:04 AM |#4  
Senior Member
Thanks Meter: 8
I'm finding this mod interesting. I first had the body glove case on my phone but then got the seidio rugged combo. Seeing the size of the 2150 in relation to the bodyglove case i think it might be possible to make the 2150 fit inside the seidio rugged. The seidio case on the phone is about 1mm thicker then the bodyglove. So i might be able to keep the outer shell the way it is now and you wouldnt be able to tell the 2150 is in there. Gonna have to get a 2150 and see what i can do.
Thanks for the inspiration.
21st September 2010, 04:37 PM |#5  
OP Junior Member
Thanks Meter: 2
Just promise to post pictures if you pull this off. My original thought with the Body Glove case was to remove the plastic inside the back of the case leaving the rubber outer layer to stretch over the phone. There was ultimately too big of a hole in the back of the case for various clips and attachments to make this worth the effort, but a case that would actually fit would be nice.
Post Reply Subscribe to Thread

Guest Quick Reply (no urls or BBcode)
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes