Ok, I've been doing some reading and I'm almost ready to flash the watch back to 1.5, but just in case I'll make here the full list of what I've done/about to do, please check if all is correct:
1 - Download and place the Platform-tools folder from here
on a easy access place to access on your PC
1.b - Edith Path Variable as shown here
just be make things easier
2 - Enable USB debugging on watch by going to the watch Settings/System/About and pressing a few times on the Build Number
2.B - To check if the connection is well done between watch and PC open a command line on Windows and write "adb devices
", it should show the watch SN listed
3 - Unlock the bootloader!
3.1 - Reboot to fastload (via *adb command* (You do this by opening a command prompt window from within windows itself) "adb reboot bootloader
3.2 - type command "fastboot oem unlock
4 - Download STOCK ROM MWG68 images
From here is where I have doubts, DON'T FOLLOW THESE INSTRUCTIONS until someone more experienced confirms if it's correct or not
5 - Place the files unziped: system.img / boot.img and recovery.img downloaded on point 4 inside the platform-tools folder in point 1
6 - Open a command prompt window and past the following code ***DOUBT*** Full code at once as shown bellow or line by line followed by enter??
fastboot flash system system.img
fastboot flash boot boot.img
fastboot flash recovery recovery.img
fastboot erase userdata
7 - make factory reset on watch by... "unpair and reset" in the watch settings...
7.1 - Re-lock bootloader is advised? How and why to do it?
8 - Don't install AW 2.0 again?
is this correct or am I missing something?