Dex connection help

[stewarta13wsb]

So my free Dex has finally arrived. Trying to connect it to my Dell 2007WFP monitor to save buying a second screen. Got a full 1080p HDMI to VGA Video Converter Adapter Cable Male to Male D-SUB 15 Pin M/M Full 1080P with 3.5mm Audio Output One-way Signal Converter-1.8m/6f as the monitor can switch between two feeds, BUT...
I get the error message - Input signal out of range, change the setting to 1680 1050 60Hz but it's already at that. I've also tried updating my graphics card driver.

Any help appreciated :fingers-crossed:

 

[vagelis]

HDMI to VGA adapter will not communicate properly the supported refresh rates through the analog interface of the VGA side, and your monitor thinks it's been set to a higher scanning frequency than it supports. The video output of the DeX is not supporting many modes. What about DVI? are you using that already with your pc?

Sent from my SM-N950U using Tapatalk

 

[stewarta13wsb]

Looks like my old Dell won't allow any higher and yes the DVI is used by PC.
Looks like a new monitor is required so the free DEX is not so free