mmhh... no good news for me... i tried to flash the firmware for sm-t815 but didn't work. then i tried to flash the original firmware (or so i think) and now i can't start the tablet. i can only make it start in download mode.
I controlled before the flash and the data were:
ap: T815YDVU1AOG6
cp: T815YDVU1AOG6
csc: T815YOLB1AOG6
So i flashed the firmware with code T815YDVU1AOG6_T815YOLB1AOG6_T815YDVU1AOG6_HOME.tar taken from sammobile
i thought it was correct but doesn't work.
odin log is:
Enter CS for MD5..
Binary Check MD5.. Do not unplug the cable..
Please wait..
Checking MD5 finished Sucessfully..
Leave CS..
Added!!
Odin engine v(ID:3.1100)..
File analysis..
SetupConnection..
Initialzation..
Get PIT for mapping..
Firmware update start..
SingleDownload.
sboot.bin
NAND Write Start!!
Transmission Complete..
Now Writing.. Please wait about 2 minutes
Receive Response from boot-loader
boot.img
Transmission Complete..
Now Writing.. Please wait about 2 minutes
Receive Response from boot-loader
recovery.img
Transmission Complete..
Now Writing.. Please wait about 2 minutes
Receive Response from boot-loader
system.img
Transmission Complete..
Now Writing.. Please wait about 2 minutes
Receive Response from boot-loader
Transmission Complete..
Now Writing.. Please wait about 2 minutes
FAIL!
Receive Response from boot-loader
All threads completed. (succeed 0 / failed 1)
Do you think it's the wrong firmware or something else??
thank you
Are you loading the firmware tar into the AP slot and which version of odin are you using?
From the output it seems bootloader, boot and recovery flash successfully, but the system.img fails.
Usually because the image has the wrong signature and is not intended for your device.
This begs the question: Why didn't you make a full backup BEFORE flashing anything?
This one thing could have saved you a massive headache.