yes,is possible to diy cradle for table s and can be recognise by it.
start from the power plug,
let's name the contact of plug from end to 1234
from the note on power adapter,we know 2 is dc+,3 is dc-
contact 1 is about the cradle.tape contact 1 then connect the plug.
look,system show cradle setting ui!
so,diy cradle is so easy:
just make some cradle size ok,
tape the 1st contact of power plug,and set it on the cradle.
done!
it will work same as official cradle
start from the power plug,
let's name the contact of plug from end to 1234
from the note on power adapter,we know 2 is dc+,3 is dc-
contact 1 is about the cradle.tape contact 1 then connect the plug.
look,system show cradle setting ui!
so,diy cradle is so easy:
just make some cradle size ok,
tape the 1st contact of power plug,and set it on the cradle.
done!
it will work same as official cradle
Attachments
-
47.2 KB Views: 3,103
-
63.7 KB Views: 3,076
Last edited: