fire 2 will not boot stuck in boot screen

dyson77

Member
Nov 27, 2012
44
0
0
my kindle fire 2 is stuck in the blue whit fire-fire screen
I can access the twrp recovery but after a incorrect wipe i have no android or so i am assuming.
i have installed the Google usb drivers through adb but the tablet will not show up i explorer
it will show as a android device but will not load anything else.
i have also booted into the twrp and attempted to mount it and it didn't work

lastly i have tried to use a fastboot cable. i get a screen on the device that says fastboot and what looks like a stoplight with the green blinking but again will not show up in explorer
 

kidicarus1602

Senior Member
Oct 8, 2011
69
10
0
my kindle fire 2 is stuck in the blue whit fire-fire screen
I can access the twrp recovery but after a incorrect wipe i have no android or so i am assuming.
i have installed the Google usb drivers through adb but the tablet will not show up i explorer
it will show as a android device but will not load anything else.
i have also booted into the twrp and attempted to mount it and it didn't work

lastly i have tried to use a fastboot cable. i get a screen on the device that says fastboot and what looks like a stoplight with the green blinking but again will not show up in explorer
First check you have fastboot drivers installed correctly:

Plug the cable into your device and then the computer. Reboot the Kindle. It *SHOULD* show a Fastboot screen. Once at the screen use this command on your computer:
fastboot -i 0x1949 devices
You should see something like this:
0123456789ABCDEF
Then enter these commands one at a time

fastboot -i 0x1949 flash bootloader otter2-u-boot-prod-10.2.4.bin
fastboot -i 0x1949 flash boot otter2-freedom-boot-10.4.6.img
fastboot -i 0x1949 flash recovery otter2-twrp-2.6.3.0-recovery.img
fastboot -i 0x1949 reboot
 

dyson77

Member
Nov 27, 2012
44
0
0
ok I have manually installed the drivers.
it then was showing up as a Otter-2
I then went through the same steps to add the drivers for it as a google usb driver.
but its still not showing up in my explorer and when i do a adb devices it doesn't show up
mind you that was all with the fastboot cable

when I hook it up with a standard usb and gho into the teamwin twrp it shows as a Kindle fire 2
and adb devices finds it as 0123456789abcdef

see attached pics
 

Attachments

Last edited:

dyson77

Member
Nov 27, 2012
44
0
0
Ok I have been able to push a file to the fire 2 but the only file that will install is cm-10.1.3-otter2.zip
when i try to install anything else i get a error 7 and then it wont boot at all when i reboot it just goes into a loop.
would like to put cm 11 on there seems a little better
 
Last edited:
Our Apps
Get our official app!
The best way to access XDA on your phone
Nav Gestures
Add swipe gestures to any Android
One Handed Mode
Eases uses one hand with your phone