If you're like me, you use your Fascinate as an audio source for your car stereo. I have done a LOT of research into the whine sound and know it is from the alternator and I have seen things to go inline with the audio, but this degrades sound, which I definitely did not want. So, without further delay, here is the link:
http://n4maa.us/alternator.htm
It is from a HAM radio guy and this puts an inductor (which causes frequencies only below a certain point to pass through) and a capacitor (which smooths out the electrical current in this case - many that have built speakers before know that this is a high pass filter as well - which means that in this "kit" it takes frequencies above a certain point and they go to ground if my electrical schematic reading is correct (If I'm wrong, lemme know!)).
To sum it up - this gets rid of the whine you get when trying to charge or cradle your phone in your car while it is hooked to the aux in of your stereo.
You'll have to find a way to put this inline with the electrical supply to your device (like get an extension cord for a cigarette lighter plug with male on one end, female on the other and splice this in the middle. NOTE: the red wire attaches to the wire that feeds the tip of the cigarette adapter. the clips or outside of it is the ground, which is the line the black wire goes to. That said, if you have issues, just reply to this thread.
http://n4maa.us/alternator.htm
It is from a HAM radio guy and this puts an inductor (which causes frequencies only below a certain point to pass through) and a capacitor (which smooths out the electrical current in this case - many that have built speakers before know that this is a high pass filter as well - which means that in this "kit" it takes frequencies above a certain point and they go to ground if my electrical schematic reading is correct (If I'm wrong, lemme know!)).
To sum it up - this gets rid of the whine you get when trying to charge or cradle your phone in your car while it is hooked to the aux in of your stereo.
You'll have to find a way to put this inline with the electrical supply to your device (like get an extension cord for a cigarette lighter plug with male on one end, female on the other and splice this in the middle. NOTE: the red wire attaches to the wire that feeds the tip of the cigarette adapter. the clips or outside of it is the ground, which is the line the black wire goes to. That said, if you have issues, just reply to this thread.
