got bricked

[abhishek biswas]

i recently bricked my a311 while swiching to stock rom via twrp it says unable to mount data, system in red color unable to do nothing what to do please help. also not taking the backup which i created via twrp same it says unable to mount please help to get life on my device

 

[akhil1_mishra]

Similar Situation for me too. I tried installing Stock ROM via YGDP but it is failing after reaching 98%. There are two problems.
1. MT65XX Preloader driver apprear for few seconds in Device Manager and then goes off.
2. Getting the below error while flashing via YGDP.
15:44:01 CELL0: Check between YL-Parames Partition and PhoneInfo Failed.
15:44:01 CELL0: Check YL-Parames Partition Failed, The CPB is not for the Phone.

Please help. Any support is much appreciated!

 

[shaijuvjohn]

Similar Situation for me too. I tried installing Stock ROM via YGDP but it is failing after reaching 98%. There are two problems.
1. MT65XX Preloader driver apprear for few seconds in Device Manager and then goes off.
2. Getting the below error while flashing via YGDP.
15:44:01 CELL0: Check between YL-Parames Partition and PhoneInfo Failed.
15:44:01 CELL0: Check YL-Parames Partition Failed, The CPB is not for the Phone.

Please help. Any support is much appreciated!

You may check this thread and try the solution provided.
http://forum.xda-developers.com/a310/help/how-to-fix-ygpd-stuck-98-flashing-stock-t3380064

 

[abhishek biswas]

my device was lucky i donot know but some how i am able to mount all the stuff from a hard reset means battery out in twrp and just restore to the back up which i had created i was very luck man there i know that a lot of people always failed to install stock rom via pc thats why i had not connected it at all now i am not going to tinker with my device at all i will stick to cm12.3 only

 

[akhil1_mishra]

You may check this thread and try the solution provided.
http://forum.xda-developers.com/a310/help/how-to-fix-ygpd-stuck-98-flashing-stock-t3380064

Thanks for replying but not much help. Still same issue.

 

[shaijuvjohn]

Thanks for replying but not much help. Still same issue.

If you are able to reboot in to recovery, then download the flashable zip of stock rom available in xda and try flashing it.

 

[akhil1_mishra]

If you are able to reboot in to recovery, then download the flashable zip of stock rom available in xda and try flashing it.

Tried earlier but not much help. But came across below link and problem solved.
http://forum.xda-developers.com/a310/general/how-to-flash-8297w-cpb-roms-roms-himax-t3380055

 

[shaijuvjohn]

Tried earlier but not much help. But came across below link and problem solved.
http://forum.xda-developers.com/a310/general/how-to-flash-8297w-cpb-roms-roms-himax-t3380055

Yeah, good. I already seen that thread, but forgot. There is always a solution for each problem in xda. Most of the custom rom users had once gone through one of these situations and there for a solution is there.

 

[buggynotme]

i assume u have flashed stockrom by brovonova....

same thing occurred to me
but in wipe option select data and repair partition
it will show fail to repair but don't worry
go to reboot and reboot recovery
you will able to mount data
just wipe it and reboot it

although u will loose u r all data in internal storage

 

[Kunal Shende]

my device was lucky i donot know but some how i am able to mount all the stuff from a hard reset means battery out in twrp and just restore to the back up which i had created i was very luck man there i know that a lot of people always failed to install stock rom via pc thats why i had not connected it at all now i am not going to tinker with my device at all i will stick to cm12.3 only

can you upload your system backup? It might work for me

 

[SHYAMBAKADE]

plz help me i lost my micromax a311 its totally dead

ygdp tool error
CELL0: Initial backup YL-Parames Failed.
CELL0: error 4009