Okay, I just installed SS3.75 but when I go to the recovery, it shows older version 3.72. I understand that I have TWRP2.7.0.0, how should I change that? Thanks very much!!!
Last edited:
I had the same problem with the odin site. I found a clean download on here down loaded the files to my phone ext sd the moved them to the computer.I'm trying to follow these directions. When I download Odin it keeps installing all kinds of Crap on my computer. Installs all kinds of Malware and never installs Odin.
Where do I get a clean copy of Odin?
Thanks for this. Really helped me out. Was trying to install objective rom and was getting a black screen after reboot. Followed your instructions and was finally able to get my phone to boot up. THANK YOU!Ok i think i mislead you a bit..bear with as I have a developer edition and flashing is a bit different.
Assuming you are on stock NC4, rooted, with latest kitkat safestrap installed, try this...
Boot into safestrap recovery
Wipe data factory/reset
Flash alliance rom
Reboot into download mode from safestrap
Flash this stock NC2 kernel in the AP/PDA slot of odin. https://www.androidfilehost.com/?fid=23501681358549122
Reboot
You can create a pit file with efsprofessional.mate how do i get pit file for note 4 910G ?
anyone?has anyone update to 4.4.4?
can I have root access on 4.4.4?
See the Jasmine roms thread, discussions there say do not take the ota.anyone?
If you take the OTA you will be stuck unrooted.anyone?
Just double checking, I'm presently running Alliance Rom with safestrap 3.72, but I'd like to go back to stock NC4 without safestrap, all I need to do is ODIN these 2 files, the NC4 tar file and the Pit file from step # 2, right?If you odin back to stock NC4 with pitfile there will be no safestrap recovery. Again reflash the full NC4 firmware that is over 1gb w/ pitfile, uncheck auto reboot, pull and insert battery, three finger into stock recovery, wipe data/factory reset, then reboot. Wait 5-10min the device should boot up.
Anyone? Going to sell this phone and want to make sure I don't screw the next person over. It seems to be working okay following the steps on the first page. Tahnks.I do not see a pit file in step 2 for returning to stock. Is it necessary?
Shouldn't need pitAnyone? Going to sell this phone and want to make sure I don't screw the next person over. It seems to be working okay following the steps on the first page. Tahnks.
The pit file is in the OP... you are not looking hard enough.Anyone? Going to sell this phone and want to make sure I don't screw the next person over. It seems to be working okay following the steps on the first page. Tahnks.
this not work am try with the PIT or only AP not working said failThe pit file is in the OP... you are not looking hard enough.