Hard bricked mi A2 lite need help to enter EDL mode

[bil23]

I unlocked eh bootloader , installed twrp then after flashing magisk ,I got a bootloop.
Afterwards i tried to flash the stock rom ,but I got the mismatching device and rom error, so decided to install a custom rom .
After I installed pixel experience P and THE SYSTEM IS DESTROYED.
So I went back to the stock rom and edited the Flash_all.bat file removing everything but the flash commands.
now I have bricked phone and I can't enter EDL mode . when I plugg it in Usb I get HS-USB Diagnostics 900E.
Any suggestion is welcome

 

[TJ1999]

Can you enter fastboot unlock the bootloader and then reboot to edl via fastboot?

 

[bil23]

Can you enter fastboot unlock the bootloader and then reboot to edl via fastboot?

thanks for your reply.
I succeded in entering the edl mode by opening the phone and shorting the JTAG pins.
After that I used mi flash tool with the srock rom and it worked

 

[anykill]

O did same mistake as you.
Can you teach me How to revive Mine?

 

[Voodoojonny]

O did same mistake as you.
Can you teach me How to revive Mine?

Just go to fastboot mode and type: "fastboot oem edl"
If you can´t enter fastboot, you have to open your phone and connect the testpoints, then connect cable to pc and releas the test-points
https://www.youtube.com/watch?v=mhsRv42rsqI - here for the redmi 6 pro (same hw as mi a2 lite) - in min 2, the test points are shown!

 

[Kineceleran]

I unlocked eh bootloader , installed twrp then after flashing magisk ,I got a bootloop.
Afterwards i tried to flash the stock rom ,but I got the mismatching device and rom error, so decided to install a custom rom .
After I installed pixel experience P and THE SYSTEM IS DESTROYED.
So I went back to the stock rom and edited the Flash_all.bat file removing everything but the flash commands.
now I have bricked phone and I can't enter EDL mode . when I plugg it in Usb I get HS-USB Diagnostics 900E.
Any suggestion is welcome

Hey look at this: https://www.youtube.com/watch?v=YctyUhBgp34
it is very simple. I know you solve the problem but this video is better.

 

[bil23]

O did same mistake as you.
Can you teach me How to revive Mine?

1- install mi flash tool and Qualcomm driver on your Pc
2- open the phone (just remove the battery connector )
3-plug a USB cable in the device
4- short the jtag pins(you can find their location in this page www mobilerdx com/2018/09/xiaomi-redmi-6-pro-test-point-boot-into-edl-9008-mode.html
7-plug the USB cable in the Pc while shortening the pins
If you do these steps mi flash tool should reconize your device and you will be able to flash it