[HELP] Unbrick RAZR i X890

[Vaizen]

Hi people, I have a big problem with my friend's Razr i, I was trying to root it, but i didn't want to unlock my bootloader so tried several methods but not a single one worked, So i tried the one for unlocked bootloaders and ended up bricking my device, Now It's stuck on fastboot mode.

I've tried to flash some brazilian firmwares via RSD lite, but it get stuck on "6/9 flashing radio_signed" SO PLEASE SOMEONE GUIDE ME TO THE SOLUTION WHAT AM I DOING WRONG?

PS: Also tried to flash an argentinian Firmware but it didn't even let me start flashing bringing the error "Faled flashing process. Unknown fastboot command. (getvar)"
PS2: Also tried the eternityprj Alternate method without RSD, and it gets stuck on flashing recovery... and it also prompts some errors you can see in the attached file.

HELP ME PLEASE AS I SAID THE RAZR IS A FRIEND'S PHONE NOT MINE, I NEED TO SAVE IT.

 

[pangyaaaaaa]

Hi people, I have a big problem with my friend's Razr i, I was trying to root it, but i didn't want to unlock my bootloader so tried several methods but not a single one worked, So i tried the one for unlocked bootloaders and ended up bricking my device, Now It's stuck on fastboot mode.

I've tried to flash some brazilian firmwares via RSD lite, but it get stuck on "6/9 flashing radio_signed" SO PLEASE SOMEONE GUIDE ME TO THE SOLUTION WHAT AM I DOING WRONG?

PS: Also tried to flash an argentinian Firmware but it didn't even let me start flashing bringing the error "Faled flashing process. Unknown fastboot command. (getvar)"
PS2: Also tried the eternityprj Alternate method without RSD, and it gets stuck on flashing recovery... and it also prompts some errors you can see in the attached file.

HELP ME PLEASE AS I SAID THE RAZR IS A FRIEND'S PHONE NOT MINE, I NEED TO SAVE IT.

your secure level was to high for a non bootloader method and if you done a method with a unlocked bootloader and your bootloader was locked thats bad.
unlock your bootloader >>WARRANTY VOID<< install cwm and use any backup. or flash the 39 gb fw but i think you have yet to unlokc the bootloader to safe it.. and be patient dont try to much stuff if your battery goes low you need a factory adapter or something like this to charge ur razr i if the battery is down.

regards hope you get it waorking again

 

[jacbarahona72]

I solved my problem this way

Hi people, I have a big problem with my friend's Razr i, I was trying to root it, but i didn't want to unlock my bootloader so tried several methods but not a single one worked, So i tried the one for unlocked bootloaders and ended up bricking my device, Now It's stuck on fastboot mode.

I've tried to flash some brazilian firmwares via RSD lite, but it get stuck on "6/9 flashing radio_signed" SO PLEASE SOMEONE GUIDE ME TO THE SOLUTION WHAT AM I DOING WRONG?

PS: Also tried to flash an argentinian Firmware but it didn't even let me start flashing bringing the error "Faled flashing process. Unknown fastboot command. (getvar)"
PS2: Also tried the eternityprj Alternate method without RSD, and it gets stuck on flashing recovery... and it also prompts some errors you can see in the attached file.

HELP ME PLEASE AS I SAID THE RAZR IS A FRIEND'S PHONE NOT MINE, I NEED TO SAVE IT.

Hello good morning


I brick 2 phones trying to get one of them and in the process did fail at 2, how the recovery?

1. - Use RSD Lite version 6.1.4
2. - Use 1 extra phone (htc wildfire root and backup CWMR in case of failure)
3. - Use a GB retail rom (CFC_8.7.1I-110_IFW-39_S7_UCASMI01E1017.0R_USASMIICSRTGB_P042_A005_S1FF_fb.xml)
4. - The phone to unbrick, put fastboot mode, switching on via the power button and vol (-) until the fastboot mode screen read "fastboot reason:" if it does not, re-try until there is
5. should not say "fastboot reason: flash failure, or anything else xxxxxx xxxx xxxxx ............"
6. - Boot rsd lite 6.1.4, select retail rom, and indicate that only "unzip" connects your motorola razr I, and it connects back to the other phone (in my case htc wildfire), which has a debug mode enabled.
7. - Note, that in the window of the Rsd Lite in row 1, the Razr I phone is detected, then you start flashing in RSD Lite 6.1.4, see screenshot of your razr I to see that data is being sent, (the other phone should not be affected and only serves as a decoy to usb drivers, Rsd lite at least do not damage to my phone)
8. - Remember flashing erase the card was in your internal Razr I therefore will lose programs, photos or music you had or downloaded to the SD or internal virtual

9. - Flashing can stop and have to do everything again, but remember that no fastboot mode screen should read:
"fastboot reason: flash failure or otherwise else xxxxxx xxxxxxx ......." must be clean that is just:

"fastboot reason: "

luck : Good:

Warning, do not take responsibility for any damage to your cell involved in the process, ......... the lure of the phone can be found on youtube and just suits the way because of my need to get my phone ........ in no way am programmer or software developer, for which only comment what turned out ok to me

excuse my bad English

 

[Vaizen]

Hello good morning


I brick 2 phones trying to get one of them and in the process did fail at 2, how the recovery?

1. - Use RSD Lite version 6.1.4
2. - Use 1 extra phone (htc wildfire root and backup CWMR in case of failure)
3. - Use a GB retail rom (CFC_8.7.1I-110_IFW-39_S7_UCASMI01E1017.0R_USASMIICSRTGB_P042_A005_S1FF_fb.xml)
4. - The phone to unbrick, put fastboot mode, switching on via the power button and vol (-) until the fastboot mode screen read "fastboot reason:" if it does not, re-try until there is
5. should not say "fastboot reason: flash failure, or anything else xxxxxx xxxx xxxxx ............"
6. - Boot rsd lite 6.1.4, select retail rom, and indicate that only "unzip" connects your motorola razr I, and it connects back to the other phone (in my case htc wildfire), which has a debug mode enabled.
7. - Note, that in the window of the Rsd Lite in row 1, the Razr I phone is detected, then you start flashing in RSD Lite 6.1.4, see screenshot of your razr I to see that data is being sent, (the other phone should not be affected and only serves as a decoy to usb drivers, Rsd lite at least do not damage to my phone)
8. - Remember flashing erase the card was in your internal Razr I therefore will lose programs, photos or music you had or downloaded to the SD or internal virtual

9. - Flashing can stop and have to do everything again, but remember that no fastboot mode screen should read:
"fastboot reason: flash failure or otherwise cuarquier xxxxxx xxxxxxx ......." must be clean that is just:

"fastboot reason: "

luck : Good:

Warning, do not take responsibility for any damage to your cell involved in the process, ......... the lure of the phone can be found on youtube and just suits the way because of my need to get my phone ........ in no way am programmer or software developer, for which only comment what turned out ok to me

excuse my bad English

Could PM Me with the instructions in spanish, there are some things that i do not understand in your english

Tried to use your method but RSD lite got stuck on "4/11 erase userdata" and the phone says "program dummy sp block for userdata" I don't thin I understood well the part of the second phone, does it have to be on, i mean normal on, or does it have to be in flashmode aswell?