LG V60 retail demo unit hard brick recovery
- Thread starter chortya
- Start date
Firmware is not compatible with demo fully.
As another Demo, i think it can work with V600N firmware.
Firmware from another models work not correct. For example if my demo lose power(unplug battery or discharge) it forget about start setting, and it make it again like firmware installed again. Someone have v600n from China?
As another Demo, i think it can work with V600N firmware.
Firmware from another models work not correct. For example if my demo lose power(unplug battery or discharge) it forget about start setting, and it make it again like firmware installed again. Someone have v600n from China?
Similar threads
Top Liked Posts
-
There are no posts matching your filters.
-
2
I confirm this method works. I flashed my phone successfully and i put finger print Sensor it also work great
Now we need to fix the modem issue I’m waiting to receive receiving Antenna to arrive from china22
flashing xbl, xbl config a / b and side a / b should turn on2
DISCLAIMER: I am not responsible for any damages this may cause as I am merely translating the guide, I am not responsible for you bricking your device because of a missed step so read carefully,
Also, Please backup your data beforehand as this does wipe the phone.
Requirements
1-LGUP 1.16.0.3 .
2-LG Mobile Driver 4.4.2
3- LG FIRMWARE V600EA20c_00_0526.kdz
!!BE CAREFUL TO DO EXACTLY AS THE INSTRUCTIONS SAY OR YOU WILL BRICK THE PHONE!!!
1. Make a backup .
2.put youR lg v60 demo into Download Mode".
1. Open LGUP.
2. Pick V600EA20c_00_0526.kdz .
3. Select "PARTITION DL".
4. Press Start. And a pop-up window will appear. In this window you can select which partitions to be flashed
5. uncheck these partitions: XBL_A , XBL_B,XBL_CONFIG_A,XBL_CONFIGE_B ,SID_A and SID_B.
after completing the process it will boot up in some minutes .1
I've never found a way to get around the 50% charging capacity though that would make everything far better. I have found a way to rid retail mode and get into security settings, but charging block still remains. No fingerprint sensor, haven't gotten stylus support to work, dual screen DOES work though. Also haven't gotten a software update since March 1, though most carrier devices have.
I use mine as a WiFi device and enjoy it minus the 50% battery.
---------- Post added at 06:34 PM ---------- Previous post was at 06:25 PM ----------
If you have a guide to get me around the 50% charging, you are god lol I've searched all over and haven't found anything except flashing a different firmware and most experiences I've come across turn out real bad
