MIB2 STD Technisat CP off By emmc

[mak_us1977]

Hi
I have MIB2 STD technisat YD5 unit
5C0035200
MST2_US_VW_PQ_P0253T

I made emmc read cable and read emmc backup

I write MST2_EU_VW_PQ_P0475T_IMG_CP_OFF_SWAP.IMG to emmc direct and unit stuck on VW logo then restart
I write PQ-CM-VW-0253.img also VW logo then restart
I write the original backup , unit work again with CP active

how can I CP off and enable FEC and SWaP for this unit and convert to EU

best regards
Mak

 

[djkns]

Hi
I have MIB2 STD technisat YD5 unit
5C0035200
MST2_US_VW_PQ_P0253T

I made emmc read cable and read emmc backup

I write MST2_EU_VW_PQ_P0475T_IMG_CP_OFF_SWAP.IMG to emmc direct and unit stuck on VW logo then restart
I write PQ-CM-VW-0253.img also VW logo then restart
I write the original backup , unit work again with CP active

how can I CP off and enable FEC and SWaP for this unit and convert to EU

best regards
Mak

You can use the 253T patch files swap/fec but not for CP. For CP you need to patch the original file from the HMI folder as the pre-patch are for the EU units or you can covert it to an EU unit first then do the patching

 

[mak_us1977]

thanks for replay
I managed to do cp off and conversion to EU

 

[LaZpanyoL]

@mak_us1977 @djkns

hello man i have same version with u. can u on cp ? with your car i want to enable my cp on my car too is it hard?

 

[vovi.vw2.0]

thanks for replay
I managed to do cp off and conversion to EU

Can you tell me how did you do the cp off and conversion to EU?