Since you're using CM13, I would suggest to try any of the latest I've made available, latest one is the one from yesterday I9195XXUCPB2, but from my experience it takes a while to figure out which one is the best one for your device, region, provider, location, etc.
I accidently destroyd the data pin on my USB connection in my S4 mini while attaching a wireless charging coil, so at the moment odin wont recignize it and there fore I am unable to test any of the new modems, untill I get a chance to replace the USB connection.
yes i did....
Poor you! I've been worried about breaking a pin ever since I've had my Mini as I have to put USB in at a slight angle and it's still feels like it catches a little, did you have this too? I thought it was just my phone.
Interesting, mine was also doing this, well I assume, as quite often I would receive some messages as soon as I touched a button on phone, it only happened a few times but too often to be a coincidence. So I thought it must be some power saving "feature" on WIFI, I wasn't bothered as it only seemed to be a max delay of 3-5min (though that's just a hunch as I never tried to test) if the phone had been inactive for a while. I also have WIFI set to "always on" & battery in "balanced" mode.
Thanks very much for the info re the rev number as I fully expect to have to replace the USB at some point (or maybe it's just that my mind is clouded by a product I was responsible for which had problems with metal fatigue on USB connector
, not my fault I just had to find a solution!).
Yes, I noticed the CPB2 modem was from Vodafone Spain (well probably as it was the only one I could find on other file hosts sites) but it's working fine for me here in Australia so far (on TPG which now uses Vodafone 4G network).
Yes, some people have used it
you are right....no difference between b1 and b2---they act the same---i only installed b1 just to b sure that not the modem version is the problem...but on mobile network 4g the message arrives immediately on the wifi arrives when i unlock the phone.
On newer versions of Android they have implemented power saving poll "PS-Poll" (PSMP,WMM, UPSD etc) This is because WIFI will use a lot of power when connected even if no data is sent, but mobile data will use very little power when no data is being sent, therefore the wifi will "sleep" while mobile data does not have to in order to still use low amount of battery. But polling should happen about every 500ms or so (I think). It will also depend on your router so problem may be there (is it running older protocol?)
my phone is on balanced mode----about router i dont know..but the messages arrived normally on stock 4.4.2+ baseband cnj6----after the update to b2 a saw this behaviour.its ok i will not post another thing about this issue....i only posted here because only after update i saw the behaviour and i thought that maybe someone else saw it.no problem
