After my phone bricked I installed latest Chinese Stable ROM in EDL mode. I chose EDL mode for two reasons (1. I suspected that the phone only works while plugged in to charge and 2. the EDL mode turns off the phone after flashing so I can plug in the charger before booting). Turns out I was right. After the flash was over I tried to boot it without charging it first and it didn't work. After I connected it to the charger it booted normally and the ROM installed successfully.
I tried it again this morning after it fully charged. Few seconds after Ii disconnected it, it turned off. When I tried to turn it back on it was just rebooting to the MI logo screen. I plugged it in the charger and it rebooted 2 times (both times it got to those three dots at the bottom of the screen) and the third time it booted normally.
I also just noticed that the phone is curved a bit (maybe less than 1mm difference between upper left edge and rest of them), maybe from wearing it in tight pockets or something like that.
I tried it again this morning after it fully charged. Few seconds after Ii disconnected it, it turned off. When I tried to turn it back on it was just rebooting to the MI logo screen. I plugged it in the charger and it rebooted 2 times (both times it got to those three dots at the bottom of the screen) and the third time it booted normally.
I also just noticed that the phone is curved a bit (maybe less than 1mm difference between upper left edge and rest of them), maybe from wearing it in tight pockets or something like that.