Need help P10+ bricked

kirukool

New member
May 12, 2011
4
1
0
Hi,
i was on VKY-L29C636 with Oreo B360. TWRP_3.2.1-0_OREO installed and rooted. bootloader unlocked
My bad i tried to unoot via supersu app and got bricked. now i cannot go to recovery.
Normal boot shows
Error!
Func NO : 10 (boot image)
Error No : 2 (load failed)
if i tried to go to recovery via vol Up + power then got
Func No : 11 ( recovery image)
Error No: 2 ( load failed)
i think i should have installed original boot.img to unroot.
installed twrp again from fastboot mode without luck.
can it be solved by installing boot.img and system.img??? but i cannot extract boot.img, system.img from update.app ( B360 firmware) via huawei rom extractor.

Thanking you...
 
Last edited:
  • Like
Reactions: fatjoez

kirukool

New member
May 12, 2011
4
1
0
You need to flash over fastboot stock recovery, ramdisk and kernel. Good luck

edit: In huaweiExtractor go to settings and uncheck this options: verify header checksum, verify file checksum and keep original timestamp
Thanks.
i could see kernel and ramdisk but cannot find the recovery although there are 4 ERECOVERY_KERNE, _RAMDI, _ VMET, _VENDO
aslo
3 RECOVERY_RAMDIS, _VBMETA, _VENDOR are there.

Edit:
Thank you very much i flashed only kernel and ramdisk and the phone is booted and in good state
Edit2: TWRP working too
 
Last edited:

rck408

New member
Feb 28, 2018
3
0
0
what are the exact commands? i have the same issue and kernel is saying FAILED (remote: partition length get error) when i try to flash it
 

sismario89

New member
Feb 28, 2018
2
0
0
helppp

I followed the procedure and installed ramdisk and the kernel but then later I can not restore via the procedure with hwota8 .. can anyone help me?I'm losing hope..I can still install the twrp. Can you help?
 

rck408

New member
Feb 28, 2018
3
0
0
fastboot flash kernel kernel.img
fastboot flash recovery_ramdisk recovery_ramdisk.img
ok i was able to flash those commands - it still doesnt boot...i was able to get twrp back tho is there something else i should try? thanks for your help.
 
Last edited:

rck408

New member
Feb 28, 2018
3
0
0
I followed the procedure and installed ramdisk and the kernel but then later I can not restore via the procedure with hwota8 .. can anyone help me?I'm losing hope..I can still install the twrp. Can you help?
im in the same situation hwota8 didnt work for me either - did you figure it out?