[Nook HD] CM10/CM10.1 General Discussion

sdgon

Member
Jun 28, 2013
12
3
0
It's so quiet here. What's the battery drain of your device? My HD+ is running CM10.1/SGT 7 SD/Hybrid. It lost 5% after 8 hr with WiFi on.
 

starbright_

Senior Member
Apr 11, 2010
1,116
179
83
Display brightness

Is there an even faster way to control display brightness as by
- Slide down
- touch brightness
- move slider ?

As the NOOK lacks of a brightness detector this seem to me of importance.
As an idea, maybe just 3 fix settings (min med max) that can be toogled (best with a Hardware key combination (press Volume butten long ?).
Take care if you device has been set to lowest brightness and you are in bright sunlight. You will have trouble to change setting blind ...

Sorry if I missed an according post - this is all new to me, and I just started reading.
 

bokbokan

Senior Member
May 15, 2011
1,317
3,211
0
Is there an even faster way to control display brightness as by
- Slide down
- touch brightness
- move slider ?

As the NOOK lacks of a brightness detector this seem to me of importance.
As an idea, maybe just 3 fix settings (min med max) that can be toogled (best with a Hardware key combination (press Volume butten long ?).
Take care if you device has been set to lowest brightness and you are in bright sunlight. You will have trouble to change setting blind ...

Sorry if I missed an according post - this is all new to me, and I just started reading.
Enable 'settings->status bar->brightness control' then you can control brightness by sliding across status bar

Sent from my Barnes & Noble Nook HD using Tapatalk HD
 

starbright_

Senior Member
Apr 11, 2010
1,116
179
83
Enable 'settings->status bar->brightness control' then you can control brightness by sliding across status bar

Sent from my Barnes & Noble Nook HD using Tapatalk HD
Sorry, that is the same mechanism that I described above. No chance to do so with a completly dimmed NOOK out in the sun - as you can't see anything on display ;)
 

supernoman

Senior Member
Mar 31, 2008
185
22
0
Battery drain...is it normal to have 1% per hour with wifi on but not used (sleep). If I set wifi to only when plugged in, I get great standby battery life.
 

ST Dog

Senior Member
Jun 22, 2013
1,122
341
0
Sorry, that is the same mechanism that I described above. No chance to do so with a completly dimmed NOOK out in the sun - as you can't see anything on display ;)
No, it's not. You don't need to see anything to use it. Just touch in the center near the upper screen edge and slide.


Play with it some in better lighting to get the feel, but I've used just that a few times when taking the Nook outside.
 
Last edited:

Mikhail S

Member
May 14, 2010
5
0
0
USB gamepad not working

Many thanks for the CM. Installed 10.1 works fine with SD cards, USB stick, external HDD. But NO joystick support. I can see my joystick with dmesg and lsusb but none of the keys and sticks seems to work. The joystick is simple inexpensive PS2 USB joypad, similar to the one shown in verygreen's video. What can I do to diagnose/fix the problem?
 

starbright_

Senior Member
Apr 11, 2010
1,116
179
83
No, it's not. You don't need to see anything to use it. Just touch in the center near the upper screen edge and slide.


Play with it some in better lighting to get the feel, but I've used just that a few times when taking the Nook outside.
Sorry, that was a misunderstanding. So if I get it right, bokbokan has describe how to enable this control mechanism and you how to use it.
Will test this later.

Other question is regarding USB:
I can't see anything happen if I connect the device with my PC. I would expect that I get a new drive at PC side.
I checked both normal and forced mode.
I have observed that LED below is sometimes green, sometimes yellow - but Battery always shows, that there is no charging.


--
Edit:
Again regarding Brightness: I don't get it.
I can set Icons in both Status bar (right) and notification bar (Left). I get this bars by sliding down.
I set the Icon in Notification bar to toogle between dimm, 50% and 100%.
But a slider (left/right or up/down) to adjust brightness - I can't set.

Setting/System/Status bar/ : there I have just Display Time, Batterystat, Notification counter.
 
Last edited:
Mar 20, 2013
19
2
0
Sorry, that was a misunderstanding. So if I get it right, bokbokan has describe how to enable this control mechanism and you how to use it.
Will test this later.

Other question is regarding USB:
I can't see anything happen if I connect the device with my PC. I would expect that I get a new drive at PC side.
I checked both normal and forced mode.
I have observed that LED below is sometimes green, sometimes yellow - but Battery always shows, that there is no charging.


--
Edit:
Again regarding Brightness: I don't get it.
I can set Icons in both Status bar (right) and notification bar (Left). I get this bars by sliding down.
I set the Icon in Notification bar to toogle between dimm, 50% and 100%.
But a slider (left/right or up/down) to adjust brightness - I can't set.

Setting/System/Status bar/ : there I have just Display Time, Batterystat, Notification counter.
Even I couldn't see any brightness slider setting on my CM10.1 (Verygreen).
Am I missing something or others...

BTW I checked in all the locations even in settings> interface & Display

---------- Post added at 12:05 PM ---------- Previous post was at 11:58 AM ----------

Hi Anybody facing any bootlogo artifacts using Verygreen CM10.1?
I haven't removed the Nook factory recovery.

During boot, I see some vdertical line artifacts and cynogenmod logo cut by half.
after 5-6 seconds it becomes fine...
anybody with similar issues..?
 

bokbokan

Senior Member
May 15, 2011
1,317
3,211
0
Sorry, that was a misunderstanding. So if I get it right, bokbokan has describe how to enable this control mechanism and you how to use it.
Will test this later.

Other question is regarding USB:
I can't see anything happen if I connect the device with my PC. I would expect that I get a new drive at PC side.
I checked both normal and forced mode.
I have observed that LED below is sometimes green, sometimes yellow - but Battery always shows, that there is no charging.


--
Edit:
Again regarding Brightness: I don't get it.
I can set Icons in both Status bar (right) and notification bar (Left). I get this bars by sliding down.
I set the Icon in Notification bar to toogle between dimm, 50% and 100%.
But a slider (left/right or up/down) to adjust brightness - I can't set.

Setting/System/Status bar/ : there I have just Display Time, Batterystat, Notification counter.
Possibly you are not using my cm10.1/sgt7 rom.



Sent from my Barnes & Noble Nook HD using Tapatalk HD
 
  • Like
Reactions: starbright_

starbright_

Senior Member
Apr 11, 2010
1,116
179
83
Possibly you are not using my cm10.1/sgt7 rom.
I didn't know this ROM. Maybe I should give it a try.
if someone is out there who has a better overview: I would be nice to have an comparison of advantages/disadvantages of the ROMs.

Beside the CM10.1 from verygreen I have noticed so far only Carbon ROM, but didn't test this.
 

BigAund

Member
Sep 12, 2012
9
0
0
Lockscreen staying locked

Hi,

I bought a Nook HD+ and promptly installed CM 10.1. for the most part it seems pretty stable, I've had a few reboots but nothing major - what I do keep getting though is the tablet locking and then when I try to swipe off the lock, it flashes for a second and then returns back to the locked screen. The only way around this is a reboot.

Its not a major problem but is a bit aggravating!

Has anyone else experienced this with the 12/7 Rom and is there a way to resolve it??

Thanks in advance
 

alexb54

Member
Jul 16, 2013
15
1
0
Hi,

I bought a Nook HD+ and promptly installed CM 10.1. for the most part it seems pretty stable, I've had a few reboots but nothing major - what I do keep getting though is the tablet locking and then when I try to swipe off the lock, it flashes for a second and then returns back to the locked screen. The only way around this is a reboot.

Its not a major problem but is a bit aggravating!

Has anyone else experienced this with the 12/7 Rom and is there a way to resolve it??

Thanks in advance
I just installed CM 10.1 as well and had this problem this morning. When I tried to unlock it, it showed the screen as unlocked then flashed and back to the lock screen. Instead of rebooting, I swiped down the quick settings and went to the settings screen. It flashed again and back to lock, but I went to settings again and it worked (not flashing anymore). Then I was able to swipe to unlock normally. I'm not sure if this would work every time, but it's worth a try.
 
  • Like
Reactions: BigAund

sdgon

Member
Jun 28, 2013
12
3
0
I just installed CM 10.1 as well and had this problem this morning. When I tried to unlock it, it showed the screen as unlocked then flashed and back to the lock screen. Instead of rebooting, I swiped down the quick settings and went to the settings screen. It flashed again and back to lock, but I went to settings again and it worked (not flashing anymore). Then I was able to swipe to unlock normally. I'm not sure if this would work every time, but it's worth a try.
I had the similar problem due to the cover. Please see page 22 in this thread.
 
  • Like
Reactions: BigAund and alexb54