Unsucessful
I've been trying to SIM unlock my LUMIA 800
NSCD Version: 1.9
SW Version: 1600.2487.8107.12070
HW Version: 112.1402.2.3
Unfortunately it appeared as follow:
Looking for phone...Done.
IMEI:
Changing phone mode...Done.
----------------------------------------------------------------------------
Looking for NAND disk...Not found.
Things to check:
1. Is the phone connected?(Plug to the USB)
2. Is it in the correct mode?(Try to switch to OSBL mode)
3. Have you installed the Qcom loader ?(Use the Install button)
----------------------------------------------------------------------------
Looking for phone...Done.
IMEI:
Changing phone mode...Done.
----------------------------------------------------------------------------
Please follow these steps:
1.Power off the phone
2.Remove the USB cable
3. Press and hold the Vol+ Button
4. Plug the USB cable, wait for the buzz
5. Release the Vol+ Button
----------------------------------------------------------------------------
Waiting for 30 seconds...Done.
----------------------------------------------------------------------------
Looking for NAND disk...Not found.
Things to check:
1. Is the phone connected?(Plug to the USB)
2. Is it in the correct mode?(Try to switch to OSBL mode)
3. Have you installed the Qcom loader ?(Use the Install button)
----------------------------------------------------------------------------
I did all those steps, have tried all normal and OSBL Mode, re-plug the USB and it always appeared the error.
Hi,Hi guys,
Here the new NSS version (0.50) that allows sim unlock if your Lumia is rooted (710,800). How to unlock:
1. Make sure all drivers are installed, phone is visible by NSS in Normal, OSBL and NAND mode
2. Make sure you have Qcom loader
3. Plug the phone via USB cable
4. Start NSS, go to Simlocks, WP7, press Unlock
5. Follow on screen instructions
Unlock works for PIN and PUK blocked phones.
Regards, Chris
I've been trying to SIM unlock my LUMIA 800
NSCD Version: 1.9
SW Version: 1600.2487.8107.12070
HW Version: 112.1402.2.3
Unfortunately it appeared as follow:
Looking for phone...Done.
IMEI:
Changing phone mode...Done.
----------------------------------------------------------------------------
Looking for NAND disk...Not found.
Things to check:
1. Is the phone connected?(Plug to the USB)
2. Is it in the correct mode?(Try to switch to OSBL mode)
3. Have you installed the Qcom loader ?(Use the Install button)
----------------------------------------------------------------------------
Looking for phone...Done.
IMEI:
Changing phone mode...Done.
----------------------------------------------------------------------------
Please follow these steps:
1.Power off the phone
2.Remove the USB cable
3. Press and hold the Vol+ Button
4. Plug the USB cable, wait for the buzz
5. Release the Vol+ Button
----------------------------------------------------------------------------
Waiting for 30 seconds...Done.
----------------------------------------------------------------------------
Looking for NAND disk...Not found.
Things to check:
1. Is the phone connected?(Plug to the USB)
2. Is it in the correct mode?(Try to switch to OSBL mode)
3. Have you installed the Qcom loader ?(Use the Install button)
----------------------------------------------------------------------------
I did all those steps, have tried all normal and OSBL Mode, re-plug the USB and it always appeared the error.