When I used the Fastboot Enhance tool to flash the payload.bin file, after the flash process finished I try to reboot but unfortunately it was dead.
No Fastboot, no EDL, no recovery, 3 buttons not working, power with up/down not working, when i connect to PC no sound that the pc recognize the phone "OP 8T", when I plug it into charger no info showing, Just black screen.
So it's working now, I'll explain everything here so it might help.
My device is OnePlus 8T DDR5 version
first, I understand what happened to me, I think the tool didn't recognize ram type automatically so it was flash DDR4 on a DDR5 device, so it made a hard brick
at this point, the idea is to connect 2 test points, and you can force your phone to enter to EDL mode, and we can do it in two ways:
1. Rootk1t giude, thax bro Rootk1t
- Removing the back panel by heating it.
- Unplugging battery
- Then use the EDL points on the motherboard to force the device to boot EDL.
- The device immediately will be recognised with just one tap on "enum" now.
- Plugging the battery again and attaching the back panel and rebooting
2. By using deep EDL cable, but not any edl cable, it must be a moded cable so it can be worked with the new security ...... this link will explain
- So i use Hydra EDL Cble V2 , you can buy it from aliexpress
- Be ready and open your MSM tool
- Press the cable button before connecting
- Connect the cable to your phone when you still pressing the button
- Then connect the USB to your PC
- It will automatically put your phone in EDL mode
- Now your phone will show in the MSM tool screen so you can revive it.
Thanks to everyone who tried to help.
Special thanks to Rootk1t , semdoc
No Fastboot, no EDL, no recovery, 3 buttons not working, power with up/down not working, when i connect to PC no sound that the pc recognize the phone "OP 8T", when I plug it into charger no info showing, Just black screen.
So it's working now, I'll explain everything here so it might help.
My device is OnePlus 8T DDR5 version
first, I understand what happened to me, I think the tool didn't recognize ram type automatically so it was flash DDR4 on a DDR5 device, so it made a hard brick
at this point, the idea is to connect 2 test points, and you can force your phone to enter to EDL mode, and we can do it in two ways:
1. Rootk1t giude, thax bro Rootk1t
- Removing the back panel by heating it.
- Unplugging battery
- Then use the EDL points on the motherboard to force the device to boot EDL.
- The device immediately will be recognised with just one tap on "enum" now.
- Plugging the battery again and attaching the back panel and rebooting
2. By using deep EDL cable, but not any edl cable, it must be a moded cable so it can be worked with the new security ...... this link will explain
Hydra Tool Gift Xiaomi, Huawei, Redmi Qualcomm EDL Mode New V2 Cable!! - GSM-Forum
Hydra Tool Gift Xiaomi, Huawei, Redmi Qualcomm EDL Mode New V2 Cable!! Hydra Tool New Type-C EDL cable Schematic With this cable you can reboot your
forum.gsmhosting.com
- So i use Hydra EDL Cble V2 , you can buy it from aliexpress
- Be ready and open your MSM tool
- Press the cable button before connecting
- Connect the cable to your phone when you still pressing the button
- Then connect the USB to your PC
- It will automatically put your phone in EDL mode
- Now your phone will show in the MSM tool screen so you can revive it.
Thanks to everyone who tried to help.
Special thanks to Rootk1t , semdoc
Attachments
Last edited: