Acceleration
Status: [Enable] - status of overclocking is enabled or disabled
Load all modules: [Enable] - load modules for overclocking
Scaling: [Ondemand] - automatic CPU frequency scaling
Clk1: [300] - the frequency of the first stage of the frequency in MHz
Clk2: [600] - the frequency of the second stage of the frequency in MHz
Clk3: [800] - the frequency of the third stage of the frequency in MHz
Clk4: [1100] - the frequency of the fourth stage of the frequency in MHz, works only on official firmware firmware 2.3 and its modes
Vsel1: [20] - voltage at the first stage of frequency
Vsel2: [32] - voltage at the second stage of frequency
Vsel3: [42] - voltage at the third level of frequency
Vsel4: [65] - voltage at the fourth stage of the frequency
con_up_threshold: [80] - system load in% above which increases the CPU frequency? Bus?
con_down_threshold: [20] - system load in% above which lowers CPU speed? Bus?
con_freq_step: [5] - frequency step?
con_sampling_rate: [160 000] - interval (in milliseconds) between polls of the state of the system. In fact, the intervals between shifts the frequency of the processor? Times in 160 seconds?
int_min_sampling_rate: [50 000] - the minimum interval (in milliseconds) between polls of the state of the system. In fact, the intervals between shifts the frequency of the processor? Every 50 seconds?
ond_up_threshold: [86] - CPU in% above which increases the CPU frequency.
ond_sampling_rate: [50 000] - the second one? interval (in milliseconds) between polls of the state of the system. In fact, the intervals between shifts the frequency of the processor? Every 50 seconds?
smt_min_cpu_load: [40] - CPU in% above which decreases the frequency of the processor
smt_max_cpu_load: [85] - CPU in% above which increases the CPU frequency
smt_awake_min_freq: [30 000] - The minimum frequency of waking up?
smt_sleep_max_freq: [30 000] - CPU frequency during sleep?
smt_up_min_freq: [1200000] - How much to increase the frequency at a time?
smt_wakeup_freq: [1200000] - Frequency of waking up. It is important to not lose calls.
smt_ramp_up_step: [250 000] - on how to increase the frequency at a time?
[Set defalut (* req reboot / don 't save!!)] - Reset all settings to
[Save] - save the settings
con_ = conservative
ond_ = ondemand
int_ = interactive
smt_ = smartass (?)
That is, this is all profile names, one from which to choose.
sampling_rate - in Hertz likely, but not in milliseconds
awake_min_freq - the minimum frequency of not sleeping
