Using Flash Tools to Flash CWM Recovery to A116
A Micromax A116 (obviously)
Steps To Follow:-
1. Install drivers for your phone using Micromax drivers.
2. Extract the Stock ROM folder and replace recovery.img with cwm recovery.
3. Extract and open the SP Flash Tools.
4. In SP Flash Tools, click on Scatter-Loading and the program will ask you the location of the scatter loading file for your device.
5. In the extracted folder of the stock rom, go to the folder named "S9201_MP_F4_B1_IN_MMX_0.16_flasher_user" and select the file "MT6589_Android_scatter_emmc" which is our scatter loading file.
Check only recovery.img, preloader and uncheck all others.
6. Switch off your phone (Remove the battery to make sure it is switched off).
7. In Flash Tool, go to Options and Click USB Mode so that it is enabled. Click options again and then go to DA Download All > Speed and finally select High Speed.
8. Click the Download option (present on the right of Firmware
> Upgrade option) and the flash tool will start looking for your phone.
9. Connect your phone now. The Flash Tool will start the flashing process, the progress of which can be viewed from a yellow progress bar at the bottom of the flash tool.
**Don't interrupt this process as it can potentially brick your device.
**Make sure no power interruption takes place. (Use a laptop to ensure this).
10. After the process completes, a green ring will appear on your device signalling that the process was successful.
11.Disconnect your phone.
CWM 188.8.131.52 :
Kernel Source :
Mt6589 Scatter File :
SP Flsh tools:-
CWM is tested working.
1. Updated to CWM 184.108.40.206
1. Fixed external memory backup issue
2. Center image is now of CWM
1. Flash this through cwm
Mahommad Abdul Sajid- Testing
THL W8- Original Recovery
Press Thanks button if I helped!!