[Q] Quarx JB build burns button LED ?

[pnrakesh]

Hi,

I have been using Quarx's JB build on my Defy+ for a while. I have noticed a problem with this build - the button LEDs have burned out. First it was the "back" button, and now both the "back" and "home" buttons have burned out. It doesn't lit up while using my device. Only time it lits up is when I adjust the "button backlight brightness", but once I exit from the settings, again the buttons don't glow.

Wanted to know if this is a s/w issue or the hardware has been damaged ? If any of you have the same problem, can you please post the solution to fix this (if possible) ?

Thanks !

 

[torpedo mohammadi]

do factory reset and wipe again ...
have you flashed the right kernel ?
kernel is the problem of such problems ...

 

[pnrakesh]

do factory reset and wipe again ...
have you flashed the right kernel ?
kernel is the problem of such problems ...

Yeah, everytime I update a new build I do a full data wipe, cache and dalvik wipe. And I am using GB kernel. There was no mention of problems with GB kernel, so I am using GB stock kernel.

PS: This problem started only with Quarx's build, earlier I was using "cherry picks", in that build I didn't find this problem (now they have stopped building CM10 for Defy+).

Also I had read about this LED burnout in Quarx's build long time back, don't remember the link.