[Q] replaced digitizer now screen is not working

[nirmit1105]

hi,

I might be posting this again so sorry for that and bad grammar if any.

I replaced digitizer on my pad and now screen is not working . i hear notification sounds coming up so i am sure that its switched on. but nothing is on the screen. and also the indication light wihich turns green when charging is also working. i am able to access internal memory fwhen connected to pc so i think everything is okay inside.

thanks

 

[lewekleonek]

Check the following after you pull the back case of the unit and then flick the main board power rocker switch to the off position:
- the LCD connector that runs across the battery - make sure that both ends of it are plugged in and make sure they are both snug. Re-seat the connectors. Make sure there are no broken pins on both sides in both the male and female parts of both connectors. Also make sure that you did not kill one of the connector wires.

You may have broken your screen when pulling it off the digitizer. One strong pull or twist too many or too much heat from the heat gun can do that.

 

[dgcruzing]

Check that you have put the ribbon connectors in properly.. I just did one late at night and found that had not locked them in right.. Also check you have the right parts as it seems there were different variations being sold