[Q]Voltage Control app -free version

[Insomaniac10]

Hey guys. I havnt used this app for a while, but just started again...it's been updated several times since I last used it.

Can someone who is familiar with the newer version tell me why everytime I start the app I get a toast notification that says "warning: assuming stock voltages"? This happens even after uninstalling/reinstalling and unapplying all tweaks. What does this message mean? Are my settings taking effect?

Thanks ahead......PS running Bali-X (voltage app compatible)

 

[yalkowni]

that means its using stock voltages .....not voltages you customized

 

[Insomaniac10]

that means its using stock voltages .....not voltages you customized

is that a guess, or are you 100% positive?

only reason i ask that is because just an hour ago i decided to try a little experiment. i used the newer version to set -50 across the board. then i uninstalled the newer version and reverted back to a previous version. once i installed the previous version, it showed that my voltages were still set at -50 across, and it did not give me any "assuming stock voltages" message. this shows that my tweaks are being applied. another thing that gives it away is that if i undervolt too far (with any version), my phone locks up. so the tweaks are definitely taking effect.

keep in mind, the app itself is not control the voltages, its just assisting you in modifying a file that controls the voltages. once you modify the file using the app, you can uninstall the app and never use it again, but your tweaks will always be there until the next time you modify the file.

with all that said, i still dont understand the message the new one is giving me haha

 

[yalkowni]

im 99.99% positive .ok to prove that im right try doing this .go to the older app and put -50 then open the newest app and it wont say that message .and of course its going to lock up cause your forcing it to run when it really cant so it just dosent do anything

 

[Insomaniac10]

im 99.99% positive .ok to prove that im right try doing this .go to the older app and put -50 then open the newest app and it wont say that message .and of course its going to lock up cause your forcing it to run when it really cant so it just dosent do anything

ok, so i set everything at -0 and uninstalled for a fresh start. i restored the older version and used that to set -50 across. then i uninstalled that, and installed the new version. -50 is still there and it is still giving me that message.

also, in the newer version, its saying that 1200mhz isnt detected. Bali-X is a 1.2ghz kernel. The older version and SetCPU both recognize the 1.2ghz capability.

 

[}{Alienz}{]

I'd use the version that came with the kernel. The newest is designed to cater a bit more towards CM7 and GB crowd.

But if your old one is not working, ALWAYS make sure you throughly delete anything it may have left before using the new one. Specifically, go and delete the settings file.

 

[Insomaniac10]

I'd use the version that came with the kernel. The newest is designed to cater a bit more towards CM7 and GB crowd.

But if your old one is not working, ALWAYS make sure you throughly delete anything it may have left before using the new one. Specifically, go and delete the settings file.

im not sure if a version was actually flashed with the kernel. either way, im sticking with the old one, because thats the one that seems to function properly.