QiMai TPU screen protector. Best I've used yet

Mr. Orange 645

Senior Member
Sep 6, 2010
3,334
1,647
253
Springfield
Disclaimer: No, I don't work for QiMai or the seller on Amazon. I'm just a guy who has been struggling with screen protectors since the S8+, and finally found one I'm 100% satisfied with. So I figured I'd share.

I was using the Cubevit PET screen protector and loved it, but it was a fingerprint magnet, and like all PET screen protectors got pretty scratched up.*Otherwise it's a FANTASTIC screen protector and only $8 for a 3-pack.

I had put a QiMai TPU screen protector on my wife's S9+, and you could barely tell it was there. I have to occasionally pick up her phone and look really close to make sure it's still on there. But since it was TPU I worried about it having that rubbery feel, and the SPen leaving marks.*

Since the QiMai was only $10 for a 2-pack, I decided to give it a try on my Note 9 anyway, and seriously, it's the best screen protector out there. It may not offer the drop protection of a Whitestone Dome, but as far as clarity and feel, there's no equal.*

It is crystal clear. Matter of fact it covers the FF camera and all the sensors, but it causes no distortion or interference. And it's almost as slick as the factory glass. It has no rubbery drag at all. And fingerprints wipe away very easy. And no indents from the SPen, unless you really dig in. Even then they disappear quickly.*

Ringke makes a similar screen protector, as does a few other companies, but I haven't tried them. Here is the link to the QiMai if you all want to try it.*

Galaxy Note 9 Screen Protector, 2-Pack QiMai Case Friendly Easy Install Screen Cover(Not Glass)[New Version]*https://www.amazon.com/dp/B07H2ZW9PG..._q.BfCbVBPDM3J


So far no interference with my cases. I use a Ringke Air, a Speck Grip, and a couple minimal generic TPU cases. So nothing that really comes far over the edge of the screen. I'll be ordering some Goosperry cases soon, but I don't see where they would interfere either.

Installation is easy, but it's also easy to get lint under it. It took me four tries. The first one was 95% perfect except for a bubble from lint in the top right corner. The second one got a bubble for an unknown reason that wouldnt go away. Small bubbles disappear after 24 hours. But this one wouldn't. Otherwise it was almost perfect.

I reached out to the seller and he sent me a free replacement 2-pack. I screwed up the first one, but finally the last one went on perfectly.

I do think I'll try the Ringke version of this screen protector next time, simply because it was a built in lint remover that picks up all lint and dust as you install automatically. But I've got no experience with the Ringke to know if it's as smooth as this one.

If you want a tempered glass screen protector, then go for the Whitestone Dome. But if you like thin, minimal screen protectors that you can't tell is there, then I highly recommend this one.

UPDATE: I accidentally tore my QiMai screen protector, so I used the opportunity to try the Ringke Dual. It's the same exact material and fit as the QiMai. It just as clear, but is slightly easier to install. It seems to be more oleophobic, yet not quote as slick as the QiMai. They are both super smooth to the touch, but the Ringke seems to have just slightly more drag to it.

But I can say I like both screen protectors and you can't go wrong with either one.
 
Last edited:

felloffthetruck

Senior Member
May 12, 2014
1,778
465
103
Disclaimer: No, I don't work for QiMai or the seller on Amazon. I'm just a guy who has been struggling with screen protectors since the S8+, and finally found one I'm 100% satisfied with. So I figured I'd share.

I was using the Cubevit PET screen protector and loved it, but it was a fingerprint magnet, and like all PET screen protectors got pretty scratched up.*Otherwise it's a FANTASTIC screen protector and only $8 for a 3-pack.

I had put a QiMai TPU screen protector on my wife's S9+, and you could barely tell it was there. I have to occasionally pick up her phone and look really close to make sure it's still on there. But since it was TPU I worried about it having that rubbery feel, and the SPen leaving marks.*

Since the QiMai was only $10 for a 2-pack, I decided to give it a try on my Note 9 anyway, and seriously, it's the best screen protector out there. It may not offer the drop protection of a Whitestone Dome, but as far as clarity and feel, there's no equal.*

It is crystal clear. Matter of fact it covers the FF camera and all the sensors, but it causes no distortion or interference. And it's almost as slick as the factory glass. It has no rubbery drag at all. And fingerprints wipe away very easy. And no indents from the SPen, unless you really dig in. Even then they disappear quickly.*

Ringke makes a similar screen protector, as does a few other companies, but I haven't tried them. Here is the link to the QiMai if you all want to try it.*

Galaxy Note 9 Screen Protector, 2-Pack QiMai Case Friendly Easy Install Screen Cover(Not Glass)[New Version]*https://www.amazon.com/dp/B07H2ZW9PG..._q.BfCbVBPDM3J


So far no interference with my cases. I use a Ringke Air, a Speck Grip, and a couple minimal generic TPU cases. So nothing that really comes far over the edge of the screen. I'll be ordering some Goosperry cases soon, but I don't see where they would interfere either.

Installation is easy, but it's also easy to get lint under it. It took me four tries. The first one was 95% perfect except for a bubble from lint in the top right corner. The second one got a bubble for an unknown reason that wouldnt go away. Small bubbles disappear after 24 hours. But this one wouldn't. Otherwise it was almost perfect.

I reached out to the seller and he sent me a free replacement 2-pack. I screwed up the first one, but finally the last one went on perfectly.

I do think I'll try the Ringke version of this screen protector next time, simply because it was a built in lint remover that picks up all lint and dust as you install automatically. But I've got no experience with the Ringke to know if it's as smooth as this one.

If you want a tempered glass screen protector, then go for the Whitestone Dome. But if you like thin, minimal screen protectors that you can't tell is there, then I highly recommend this one.
Nice, is it just a film protector?
 

felloffthetruck

Senior Member
May 12, 2014
1,778
465
103
Was just looking at the Ringke and it has no install guide.

I've always hated film protectors but might give this one a try.

Does it peel off easy and clean?
 

PuffinNugz

Senior Member
Aug 3, 2010
1,154
305
113
Indy
So my first package of tg was a failure. Neither stuck to the screen. Returning to Amazon. My whitestone (which I'm not sure now if I'll end up using now) is still a few days away, so I ordered this to have coverage. It will be here tomorrow.
 

Mr. Orange 645

Senior Member
Sep 6, 2010
3,334
1,647
253
Springfield
Was just looking at the Ringke and it has no install guide.

I've always hated film protectors but might give this one a try.

Does it peel off easy and clean?
Yes it peels off easy and clean. No adhesive residue.

I actually JUST switched to the Ringke screen protector. LOL. I put my Note 9 in a sleeve to carry it without a case, and the corner of the screen protector peeled up and tore. So I ordered the Ringke to try it out. I like it just as well as the QiMai. There's some subtle differences. The Ringke is actually easier to install. And even though the QiMai feels just slightly slicker than the Ringke, I think the Ringke is more oleophobic. You honestly can go wrong with either one.

So my first package of tg was a failure. Neither stuck to the screen. Returning to Amazon. My whitestone (which I'm not sure now if I'll end up using now) is still a few days away, so I ordered this to have coverage. It will be here tomorrow.
What did you think of it?
 

felloffthetruck

Senior Member
May 12, 2014
1,778
465
103
Yes it peels off easy and clean. No adhesive residue.

I actually JUST switched to the Ringke screen protector. LOL. I put my Note 9 in a sleeve to carry it without a case, and the corner of the screen protector peeled up and tore. So I ordered the Ringke to try it out. I like it just as well as the QiMai. There's some subtle differences. The Ringke is actually easier to install. And even though the QiMai feels just slightly slicker than the Ringke, I think the Ringke is more oleophobic. You honestly can go wrong with either one.



What did you think of it?

How well does the dust removal deal work on the Ringke?
 

Mr. Orange 645

Senior Member
Sep 6, 2010
3,334
1,647
253
Springfield
How well does the dust removal deal work on the Ringke?
Not that great, actually. I think they could have used a little stronger adhesive, but it's okay. I wound up with one speck of dust on the very edge, but I also used a dust absorber from another screen protector kit to remove any heavy lint and dust.

It turned out about 99.9% perfect, which is the best I can expect from any screen protector. I always end up with some speck of dust or bubble somewhere. It's just so hard without an actual clean room.

I will say the screen protector is absolutely invisible. You have to look very hard to see it. And the more I use it, the slicker it feels.

Just make sure it's straight and aligned before you peel off the backing (tab 2 and 3). I had to readjust mine a few times to get it straight and centered left to right. That is one advantage to this installation method. You can readjust it as much as you want before you actually secure it permanently to the screen.
 

felloffthetruck

Senior Member
May 12, 2014
1,778
465
103
Not that great, actually. I think they could have used a little stronger adhesive, but it's okay. I wound up with one speck of dust on the very edge, but I also used a dust absorber from another screen protector kit to remove any heavy lint and dust.

It turned out about 99.9% perfect, which is the best I can expect from any screen protector. I always end up with some speck of dust or bubble somewhere. It's just so hard without an actual clean room.

I will say the screen protector is absolutely invisible. You have to look very hard to see it. And the more I use it, the slicker it feels.

Just make sure it's straight and aligned before you peel off the backing (tab 2 and 3). I had to readjust mine a few times to get it straight and centered left to right. That is one advantage to this installation method. You can readjust it as much as you want before you actually secure it permanently to the screen.
Can you post a couple pictures showing this protector on the phone?
 

Mr. Orange 645

Senior Member
Sep 6, 2010
3,334
1,647
253
Springfield
WOW, that looks nice. I'll have to give them a try. :)

Did you get that result on the first try?
Yes I did. But I cheated a little. I also bought the same screen protector for my Note 8 and installed it first. So I at least had some practice.

Just use as close to a dust free environment as you can. Then clean your screen really well, remove all dust with a dust remover if you have it, then take your time lining up the screen protector. Remember, you can lift it and readjust as many times as you want before you pull tab 2 and secure it permanently.
 
  • Like
Reactions: felloffthetruck