Restore back to Windows mobile ?

dertester123

Senior Member
Oct 11, 2008
960
202
0
Kinda hard when the phone isn't recongized by the rom update :)
.You must start in bootloader mode (camerabutton while reset for orbit2, think polaris is same button)

.Then plug in the usb and windows should install the driver (must have active sync or mobile device center installed)
=> Now updateutil should find your phone
......

If both are not working, there was a thread where you can flash via sd card, but dont know much about it.
.......

One question:

Do i need to install a radio first? As far as i know a nand android wipes the radio too and pcarvalhos rom dont have radio, or?
 

Nick14

Senior Member
Nov 29, 2009
152
29
0
Gothenburg
What's happens when you pull out the battery for few seconds and replace it ? After long press camera button and power ?

If no issues : is that the camera button works ?

Cheers.
the camera button is working thank god :) i reach the bootloader but Update won't recongize it even there but i did before when i had windows mobile ,
 

dertester123

Senior Member
Oct 11, 2008
960
202
0
You dont give much information what ur doin...

so some questions to help people help ;D

So does windows brings a message "driver bla bla?"

If you get some reaction from windows just look if it finds a driver.
This was a problem once i hadnt installed windows mobile device center like i wrote before

If you dont get any reaction, try different usb cable or usb port.
Clean usb port at your device(polaris)
---------

Have u searched about the sd flash yet?
 

l1q1d

Retired Recognized Developer
Sep 19, 2008
1,134
95
0
Venice
www.tech-team.it
I suggest you to use sd method.

Prepare a POLAIMG.nbh (from a windows one version), put it in a sd card (FAT32 Formatted).
  • Press and hold camera button
  • press reset (hold always camera)
  • the multiple color boot loader start,
  • after while it will appear sd flash interface,
  • release camera button
  • press power button and wait.
 

Nick14

Senior Member
Nov 29, 2009
152
29
0
Gothenburg
I suggest you to use sd method.

Prepare a POLAIMG.nbh (from a windows one version), put it in a sd card (FAT32 Formatted).
  • Press and hold camera button
  • press reset (hold always camera)
  • the multiple color boot loader start,
  • after while it will appear sd flash interface,
  • release camera button
  • press power button and wait.
i wish i could :/ but my memory card failes at formating to fat32 :(