[ROM][10.0][OOS Cam] crDroid v6.13 [21.12.2020]

Status
Not open for further replies.
Search This thread

frostysax

Senior Member
Jul 29, 2010
147
18
There is a .75 available also
Maybe try older .70 (deemed most stable)
If all fails, send a twrp install log maybe something there to look at or just clean install from oos
No one complained so far about issue like so
It's giving me error 64 in red letters. I went back and installed twrp .70 and no change, it will not flash gapps!
 

frostysax

Senior Member
Jul 29, 2010
147
18
Sorry for the mix up guys but it's all my fault! I was flashing the first gapps package I saw assuming it was the right one but as it turns out I was indeed flashing the wrong gapps....lol. Thanks for all the input though, it's much appreciated. The error 64 was meant to let me know I needed an arm 64 gapps package.
 
Last edited:

frostysax

Senior Member
Jul 29, 2010
147
18
How long does it usually take to boot up after first clean install after flashing gapps?
Don't quite understand, I can finally flash gapps but I can't get the rom to boot up. No matter how I flash gapps it always gets stuck on the boot animation. I'm truly lost again on this. I like the rom because I can get it booted up and working as long as I don't flash gapps.
 

RandomPooka

Senior Member
Oct 14, 2010
4,007
2,487
Kent, OH
Don't quite understand, I can finally flash gapps but I can't get the rom to boot up. No matter how I flash gapps it always gets stuck on the boot animation. I'm truly lost again on this. I like the rom because I can get it booted up and working as long as I don't flash gapps.
Did you format data from TWRP after flashing everything? (Not the same as wiping data. Formatting is the one that requires you to confirm by typing YES)

Encryption of the data partition when coming from a different ROM will prevent booting. That also applies to going back to OOS or switching to a different custom ROM.
 

gwolfu

Senior Member
Mar 28, 2013
2,904
11,788
where GPS points to
www.paypal.com
Don't quite understand, I can finally flash gapps but I can't get the rom to boot up. No matter how I flash gapps it always gets stuck on the boot animation. I'm truly lost again on this. I like the rom because I can get it booted up and working as long as I don't flash gapps.

installed clean?
just make sure to follow install steps described on op
if bootloop, go to PC and issue adb logcat > log.txt and send the file over
that way I can check what is going on in your case
 

frostysax

Senior Member
Jul 29, 2010
147
18
Did you format data from TWRP after flashing everything? (Not the same as wiping data. Formatting is the one that requires you to confirm by typing YES)

Encryption of the data partition when coming from a different ROM will prevent booting. That also applies to going back to OOS or switching to a different custom ROM.
Ok, when I format data it wipes everything from the phone, so I have to put the ROM, twrp and magisk back on my phone while I'm in twrp from my PC.
So I reboot to back to twrp and flash the ROM and twrp installer, reboot back to twrp and flash gapps. Is there something I'm missing as far as when I format data? Should my zip files still be somewhere in my storage after formating? Oh, I managed to flash another ROM using gapps nano. I haven't tried nano with this one yet.
 
Last edited:

H4X0R46

Senior Member
Oct 1, 2013
2,129
716
I noticed that any screen recorder on the play store causes this rom to freeze. Like, bad enough to where it's hard to even get the phone to reboot. Is this normal?
 

frostysax

Senior Member
Jul 29, 2010
147
18
installed clean?
just make sure to follow install steps described on op
if bootloop, go to PC and issue adb logcat > log.txt and send the file over
that way I can check what is going on in your case
Ok, I'm finally up and running with gapps installed as well. The only I did different this time was use nano gapps 10 arm 64. I was using a gapps arm 10 arm 64 but it would never boot up. I used nano and here I am! I love the rom and believe it or not I've been contemplating flashing this for months but never pulled the trigger until now. Anyways I'm going to take a look around and see what this awesome piece of work is all about. Thanks for all your help and input, I'm sure I'll be back with more stupid question.......LOL!!!
 

imatts

Senior Member
Oct 17, 2012
406
91
Does rounded-corner radius setting slider work in this rom? Changing it in Havoc / Bliss has no effect, only statusbar padding works. I even tried rebooting :(
 

UnwiredPS

New member
Jan 2, 2020
4
2
Makati City
How do you test?

I just used an app where you can autorotate between portrait and landscape (e.g camera, Chrome). To check if the sensors were working, I used an app named Gyroscope Test by Nova.Labs (free on Play Store, unable to post link), and accelerometer, magnetometer and gyroscope were not detected, while they were all detected on OOS. This was flashed from 10.3.0 as the base, reflashing from same ROM and formatting data didn't work, idk about other OOS 10 versions.
 
Last edited:

imatts

Senior Member
Oct 17, 2012
406
91
Use magisk app i think its called g visualizer or something like that just search the magisk repo

I tried that, it doesnt work. You are referring to "rectangle UI" option in g-visual which squares everything off. It works for most elements but not the corner overlay. Thank you for trying though!
 
Status
Not open for further replies.

Top Liked Posts

  • There are no posts matching your filters.
  • 58
    BE3pE0l.png

    Code:
    *** Disclaimer
    I am not responsible for any damage you made to your device
    You have been warned


    crDroid is designed to increase performance and reliability over stock Android for your device also attempting to bringing many of the best features existent today


    Features:
    https://github.com/crdroidandroid/crdroid_features/blob/10.0/README.mkdn

    Flashing Instructions:

    Pre-installation:

    First time installation:
    If coming from any other ROM, it's recommended to flash OOS and boot to it once in order to update firmware.
    If you already have TWRP and OOS installed, boot to TWRP and just follow step 1 (backup) and jump to step 6 (format data)
    • Backup your data to PC, OTG flash drive
    • Reboot to fastboot
    • Boot to TWRP.img (fastboot boot twrp.img) and then sideload twrp.zip (adb sideload twrp.zip)
    • Reboot to TWRP
    • Flash OOS 10 and TWRP installer then reboot to TWRP
    • Format data
    • Flash crDroid zip then reboot to TWRP
    • Flash OpenGapps and reboot to system
    • After passed setup screen, reboot to TWRP and flash Magisk zip
    • Enjoy

    Update installation:

    TWRP way (faster):
    • Boot to recovery and make a backup
    • Flash crDroid zip then reboot to TWRP
    • Flash OpenGapps, Magisk and reboot to system
    • Enjoy
    Built-in OTA (slower):
    • Go to crDroid Settings > About crDroid > Updates
    • Click on Download button for new update and after download is ready, click install
    • Updater app will prepare for first boot then finalize installation, but make sure you don't click reboot (you'll loose root if you do so)
    • Open Magisk and click top install button, then click install button again from the prompt, and install to inactive slot
    • Reboot and enjoy


    Sources:
    ROM: https://github.com/crdroidandroid
    Kernel: https://github.com/crdroidandroid/android_kernel_oneplus_sm8150

    Download:
    ROM https://crdroid.net/guacamole#crDroid-v6
    Changelog: https://raw.githubusercontent.com/c...endor_crDroidOTA/10.0/changelog_guacamole.txt

    Known issues:
    - bug free baby (unless some source issues)

    Visit official website @ crDroid.net
    crDroid OnePlus 7 Pro Telegram
    crDroid Community Telegram

    If you like my work, consider a donation > My Paypal


    ROM OS Version: Android 10
    ROM Kernel: Linux 4.14
    26
    Build 20191129 is ready

    Changelog:
    - Added new crDroid Kernel
    - Updated kernel to Linux 4.14.156
    - Added Dialer dark theme
    - Added Dialer call auto record option
    - Added high brightness mode toggle
    - Added DC-Dimming toggle
    - Added panel modes (sRGB, DCI-P3, Night mode, Wide Color mode)
    - Added notification slider customization options
    - Added vibrator strenght customization
    - Fixed system crash on theme change
    - Improved Theme Engine
    - Some other small changes

    Join the chat on Telegram @ https://t.me/crDroidOP7Pro
    Download: https://crdroid.net/guacamole
    26
    Build 20191028 is live

    Alright, so this is a big one...

    Changelog:
    - Updated to OOS OB4 blobs
    - Added back battery percentage customization (both in status bar and in QS)
    - Added Lockscreen album art filter
    - Added lockscreen visualizer pulse
    - Enabled burn-in protection
    - Enabled Dash/Warp charger support
    - Added volume livesteps
    - Add ability to toggle bluetooth battery level
    - Added back Gallery2
    - Added back Trebuchet
    - Added crDroid Music app
    - Improved dark theme
    - Improved media seek bar
    - Tweaked automatic brightness
    - Improved recorder app
    - Enabled auto brightness while dozing (testing)
    - Boosted volume
    - Some other small changes here and there

    Join the chat on Telegram @ https://t.me/crDroidOP7Pro
    PS. Thank you all for your kind donations, motivated me a little to work over nights with some more coffee :D

    MEGA mirror for this build: https://mega.nz/#!FsFlRKiL!wohHTcBDsLEJfNgQsWd7TCduqocp9A_uyFd4iYZh3Vg
    25
    Build 20191231 is ready

    Happy new years eve everyone!

    Changelog:
    - Initial crDroid 6.1 code
    - Updated to December Security patches
    - Completely rebased code to new android-10.0.0_r18 tag
    - Added toggle to hide power menu on secured lock screen
    - Added toggle to display advanced reboot on secured lock screen
    - Added toggle for restart systemui in advanced reboot menu
    - Added in-built screen record customizations - power menu, tile and removed Recorder app
    - Added screenshot type selection for volume button trigger
    - Added aggressive battery customizations (crdroid > misc)
    - Added new font styles including Google Sans, OnePlus Slate and SamsungOne
    - Added new icon shape styles - hexagon and cylinder
    - Added new dark styles - Carbon Black and Amoled Black
    - Fixed settings for ambient display sensor based customizations
    - Maybe more that I forgot

    Join the chat on Telegram @ https://t.me/crDroidOP7Pro
    Download: https://crdroid.net/guacamole
    22
    Build 07.06.2020 is ready

    Changelog:
    - Initial crDroid 6.7 code
    - Updated to June Android Security patches
    - Updated kernel to Linux 4.14.183
    - Added per-app sensor block option
    - Added automatic HBM lux threshold control
    - Added Ambient Edge Pulse layout
    - Added OxygenOS styled dismiss all button
    - Enabled RW for NTFS mounted storage
    - Enabled X-Box gamepad support
    - Enabled nintendo switch controller support
    - Reworkd FOD implementation (again I know)
    - Reworked quick QS brightness slider
    - Improved system strenght vibration option from OP Settings
    - Improved Automatic HBM
    - Fixed new clocks preview layout in settings
    - Fixed issue with popup camera launching on phone call close
    - Fixed an issue with data not connecting on reboot
    - Optimized system performance
    - Some other small changes
    - Updated translations

    Join the chat on Telegram @ https://t.me/crDroidOP7Pro
    Download: https://crdroid.net/guacamole
Our Apps
Get our official app!
The best way to access XDA on your phone
Nav Gestures
Add swipe gestures to any Android
One Handed Mode
Eases uses one hand with your phone