[ROM][Elemental V3(XGPUTurbo Gaming)] EMUI 8.0.0 Huawei P10 Lite (Dual Sim)

[Anto2134]

Hi I have a single SIM, can I use this rom or i can't use it yet? Thanks for answer and for my bad English

 

[hdemary]

hello, EMUI 8.0.0 is now available for WAS-LX3C605 free version, now you can update so you do not lose the 4g, and if you want you can install the elemental rom

Thanks! I currently on Elemental V4, when i Get Home i will try this one, it´s seems really nice when i try LX1 versión.

 

[S1thh@ck3r]

...

Thanks! I currently on Elemental V4, when i Get Home i will try this one, it´s seems really nice when i try LX1 versión.

but update to EMUI8 before installing this because you will brick if you install this on EMUI 5.1

 

[Gamered2509]

Hello!

I have LX3 when i rebrand to LX1 and flash oreo y did not have 4G, with this rom will be the same? Any one already did in LX3?

Thanks in advance

I have the same question. I upgraded to Oreo and 4G dont work anymore, Its there any solution?

 

[KingOfMezi]

I have the same question. I upgraded to Oreo and 4G dont work anymore, Its there any solution?

if you have problems with 4G, and you are WAS-LX3, you have to update ah emui 8.0.0 according to your version, for example, it is already available Android Oreo, WAS-LX3C605B321-log (8.0.0.321), this will solve your problem

 

[hdemary]

but update to EMUI8 before installing this because you will brick if you install this on EMUI 5.1

Thanks for the remember! i was thinking about that, but oreo for 605 is already out, so i will update to oreo by hwota then install Elemental.

 

[roxkiller]

I can not install the oreo stock in lx3, says that the firmware version has not yet been approved. Any solution?

 

[KingOfMezi]

I can not install the oreo stock in lx3, says that the firmware version has not yet been approved. Any solution?

guiate of this video ami served me a lot, when update to WAS-LX1 EMUI 8.0.0, everything is the same in your case you will update to WAS-LX3 EMUI 8.0.0
post original: https://xdaforums.com/p10-lite/development/hwota-huawei-p10-lite-t3776186

 

[roxkiller]

guiate of this video ami served me a lot, when update to WAS-LX1 EMUI 8.0.0, everything is the same in your case you will update to WAS-LX3 EMUI 8.0.0
post original: https://xdaforums.com/p10-lite/development/hwota-huawei-p10-lite-t3776186

Is it necessary to be in the stock rom or can I do the elemental procedures?

 

[Gamered2509]

if you have problems with 4G, and you are WAS-LX3, you have to update ah emui 8.0.0 according to your version, for example, it is already available Android Oreo, WAS-LX3C605B321-log (8.0.0.321), this will solve your problem

It works flawlessly, thank you so much. I will try this rom now.

 

[roxkiller]

was on android 8.0.0 and emui 8.0, from there I followed the steps to install the Elemental version, now I'm with bootloop.

 

[KingOfMezi]

was on android 8.0.0 and emui 8.0, from there I followed the steps to install the Elemental version, now I'm with bootloop.

you have to install the kernel and ramdisk, did you do it? comes with your automatic installer
We turn Off The Phone And Enter The Fastboot Mode:
-Decompress File:
Elemental-Kernel+Ramdisk.zip
We Open update.bat Press Enter
-Automatically Install Ramdisk and Kernel
Initial Configuration,Initial Start And Enjoy....

 

[roxkiller]

you have to install the kernel and ramdisk, did you do it? comes with your automatic installer
We turn Off The Phone And Enter The Fastboot Mode:
-Decompress File:
Elemental-Kernel+Ramdisk.zip
We Open update.bat Press Enter
-Automatically Install Ramdisk and Kernel
Initial Configuration,Initial Start And Enjoy....

yes, I followed the steps, I lowered the rom again, and I will try again, sometimes it was corrupted. I'll be back in 20 minutes with new information

 

[KingOfMezi]

yes, I followed the steps, I lowered the rom again, and I will try again, sometimes it was corrupted. I'll be back in 20 minutes with new information

-Install recovery twrp
-Install Rom elemental
-Install update_data_full
-When Finish, We Give In Reboot System...
We turn Off The Phone And Enter The Fastboot Mode:
-Decompress File:
Elemental-Kernel+Ramdisk.zip
We Open update.bat Press Enter
-Automatically Install Ramdisk and Kernel
try this:
-Decompress File:
https://mega.nz/#!fRZUgAyS!LbIs8ntFFgRVplgcs0pQo_1Ou1vncF5rKygVKec3um8
Enter The Fastboot Mode,We Open The Cmd Window And Write These Codes:

fastboot flash recovery_ramdisk recovery_ramdisk.img

Reboot To Stock Recovery By Vol+ And Power Button
Do a Factory Reset And Reboot System We do Initial Configuration
Initial Start And Enjoy....

 

[roxkiller]

try this:
-Decompress File:
https://mega.nz/#!fRZUgAyS!LbIs8ntFFgRVplgcs0pQo_1Ou1vncF5rKygVKec3um8
We turn Off The Phone And Enter The Fastboot Mode,We Open The Cmd Window And Write These Codes:

fastboot flash recovery_ramdisk recovery_ramdisk.img

Reboot To Stock Recovery By Vol+ And Power Button
Do a Factory Reset And Reboot System We do Initial Configuration
Initial Start And Enjoy....

I got success now, and to install xposed, how do I? can I install the normal version?

 

[KingOfMezi]

I got success now, and to install xposed, how do I? can I install the normal version?

There's still no xposed for EMUI 8.0.0, when it's available, I'll add it to the elemental rom

 

[roxkiller]

There's still no xposed for EMUI 8.0.0, when it's available, I'll add it to the elemental rom

Thanks. Which camera has the best quality p20 pro or mate 10 for me to install?

 

[Gamered2509]

I got success now, and to install xposed, how do I? can I install the normal version?

try this:
-Decompress File:
https://mega.nz/#!fRZUgAyS!LbIs8ntFFgRVplgcs0pQo_1Ou1vncF5rKygVKec3um8
We turn Off The Phone And Enter The Fastboot Mode,We Open The Cmd Window And Write These Codes:

fastboot flash recovery_ramdisk recovery_ramdisk.img

Reboot To Stock Recovery By Vol+ And Power Button
Do a Factory Reset And Reboot System We do Initial Configuration
Initial Start And Enjoy....

Works for me too, Im so happy. I was really scared about the bootloop

 

[miladah]

Tnx.I installed this rom successfully. But only problem with fingerprint I'd. Fingerprint isn't work for me.scaning page automatically closed

 

[KingOfMezi]

Thanks. Which camera has the best quality p20 pro or mate 10 for me to install?

You can use the one you like most, it all depends on you

Works for me too, Im so happy. I was really scared about the bootloop

I understand you calmly, in emui 8.0.0 things have changed, now everything is a bit difficult to flash a custom rom

Tnx.I installed this rom successfully. But only problem with fingerprint I'd. Fingerprint isn't work for me.scaning page automatically closed

What model do you have?
This rom is based on WAS-LX1C432B321 EMUI 8.0.0
If You Have Some Problems With The Rom,Everything Is Slow In Applications,Fingerprints,Music,Etc
Re-Install The Rom,Without Any Cleaning The Problem Will Be Solved
Flash update_full_elemental

edit: If the problem persists, you can convert your device to version WAS-LX1C432B321, so as not to have any problems, use this guide.