Another build is up, August Security patches in.And just a day later, August Security Patches was released...
Another build is up, August Security patches in.And just a day later, August Security Patches was released...
Hi, what is the firmware version in which you unlocked the bootloader?Hello every one,
i need your help here, because it gets a bit confusing for me.
I unlocked the bootloader and now i am not sure what is the next step.
How do i install a custom recovery on this device? Is it enough to just flash the boot.img included in this rom (inbuild recovery) or are there other steps to do?
I searched the forum, but i couldn´t find enough evidence to be sure enough to do it.
Thank you for your help in advance.
Solved the Problem:
1. I installed twrp_3.1.1-0 through fastboot (fastboot flash boot xxx.img)
2. booted in twrp (Power + Vol_Up)
3. followed the steps in OP
I was on 10.7.A.0.228 before and just unlocked bootloader and flashed twrp afterwards.
First went!!!A few good news: now all fusion3 devices will receive official builds of LineageOS 14.1 - https://review.lineageos.org/#/q/topic:fusion3-cm-14.1+(status:open+OR+status:merged) . The first build for Xperia ZL can be downloaded on Thursday(21/09) at https://download.lineageos.org/![]()
Need clean installationI dirty flashed but got error 7 every times .
how can i do??
For the first official build:I dirty flashed but got error 7 every times .
how can i do??
Unbricked. Used flashtool to install a stock 4.4.4 firmware. Went through the process of rooting, installing the recovery and also unlocked the bootloader, which I think it was my fault (the bootloader was unlockable, not unlocked). I ended up flashing the official nightly build and seems to be working ok.Hi,
I was using 4.4.4 official (C6503_10.5.1.A.0.292_Customized_NCB), rooted with the bootloader unlocked (dual recovery) and decided to upgrade, after backing up.
In TWRP, I cleaned the dalvik cache, the cache and data partitions but did not install the rom's kernel. Then I flashed the rom zip, and gapps pico (open_gapps-arm-7.1-pico-20171002.zip). After rebooting, I don't even see the boot animation, only a blinking red light.
I've only been able to see the device in flash mode under flashtool, but I'm not sure what should I do now. Help will be much appreciated.
It's the latest TWRP 3.1.1.0 IIRC.What recovery is the ROM using when you don't have a FOTA recovery?
Guess I have a FOTA-Setup then since my device with ROM (14.1-20171001-nightly-odin) gives me a TWRP 3.0.2 and seems to have some trouble accessing storage.It's the latest TWRP 3.1.1.0 IIRC.
I think flashing the boot.img (and then booting into the built-in recovery with volume up during boot) should be sufficient but I can't tell for sure as I only have the built-in recovery.I guess I should flash the boot.img from the zip then or do I have to do something else to remove the FOTA Recovery setup?
According to the official LineageOS Install guide for odin, when you push volume down during boot you get the inbuilt recovery and volume up boots a FOTA recovery, if you have one.I think flashing the boot.img (and then booting into the built-in recovery with volume up during boot) should be sufficient but I can't tell for sure as I only have the built-in recovery.
Volume up boots the latest TWRP, volume down boots the same "Android Recovery" you mentioned. I'm kinda confused which one is FOTA now...According to the official LineageOS Install guide for odin, when you push volume down during boot you get the inbuilt recovery and volume up boots a FOTA recovery, if you have one.
Volume up boots the aforementioned TWRP 3.0.2, therefore FOTA. Curiously, volume down (most likely the inbuilt one) gives me a weird "Android Recovery" with a simple non-touch UI.
What does your not-messed-with Xperia ZL give you?