Hello everyone,
I am on the 4.0 build of the rom on my PX5 head unit from Xtrons (bought the OTA code and are awaiting it), The rom itself is running fine for the most part, but I am moving it to a new car with Steering wheel controls (SWC). To facilitate the communication, I have bought and attached the AXXESS ASWC-1 and gotten it hooked up from a car perspective. However, i cannot get the head unit to recognize any of the commands.
My head unit (The TE706PL) has a Key1 (brown), Key2(brown/white), and a ground (brown/black). As per the adapter's instructions, I connected brown to brown and left the ground off entirely, but nothing is happening. I did get the device to recongize something from the wiring at some point, but i think that was during a reboot or something, and I can reproduce it.
I dont know if this is a rom issue or a head unit issue or a rom issue, but I figured this was the best intersection of people in the know.
Anyone have success getting this to work with an ASWC-1 or get it working with a 2 SWC wire setup?
Any help would be appreciated. Thanks.
UPDATE: Ignore this post (and delete it if you like.
Turns out that I needed to change the radio type, even for analog signals like this. For me, type 4 allowed me to map all 6 buttons in the OS. If anyone else finds this message and is stuck in the same spot, match the key wires (brown to brown and brown/white to brown/white) leave the ground (brown/black) free, and set to radio type to 4 (or whatever one works) and you should be good. Note though, that when you change the radio type, if you need to change it again, you will need to power cycle the device each time.