[ROM][UNOFFICIAL][10][Q]LineageOS 17.1 for z5c (suzuran)

[sabotage154]

i flashed this and in my battery is draining at a rate of 10% per hour with screen off. i tried doing a fresh reinstall of stock and then flashed the rom again and im still having the issue. anyone have any ideas what could be causing this.

i beleie i solved this issue. for me battery drain seems to be device specific and not rom based. it appears the battery on my device is bad.

 

[roohooo]

Probably two stupid questions, but:

1. How do I check "advanced" phone status with LOS17.1 like with the service menu of the stock ROM? For example rooting/unlock status, security config, etc.?
2. Does installing LOS17.1 replace the stock modem software in any case? How do I check what modem is currently being used?

Thanks!
r.

 

[Berni-0815]

1. There is a menu *#*#info#*#* but this does not fit all of your needs.
2. I'm not sure. In fact, I really don't know.

 

[roohooo]

Thanks, I had already tried the info but as you suspected this does not give me all the info I'm looking for.

 

[roohooo]

Good morning all,

over the last 4 days, I've noticed a severe degradation of my main Z5C's connectivity, which has been running fine with the 20210615 build since July. General signal strength is low and data connection sometimes takes minutes to establish before it shows "LTE" but even then there is no data flow with apps.

This happens with 2 different SIM of different providers. Both SIM are working fine in another Z5C with the older 20210208 build. So, the SIM appear to be ok and a provider issue seems unlikely. I've reset app and WiFi/mobile data settings but no effect.

@Berni-0815 and others: any ideas what I am seeing here? Is my Z5C dying? Anything else I could try without having to do a factory reset and/or fresh LOS install?


Any suggestions are very much appreciated!
Thanks,
r.

A quick update on this one: the issue does not occur when the phone is configured to GSM only. Data transfer via Edge is working...well...'nicely' and I don't have any issues connecting. Meanwhile I suspect the main antenna may have taken a hit during a recent fall of the phone. I'll try to replace it when I find the time and report back.

 

[Berni-0815]

New version out; see 1st post.

• Android security patch level: 5 December 2021

 

[petefoth]

I have just made an up-to-date unofficial LineageOS for Microg build for suzuran based on Berni's ROM. Available in this folder on AndroidFileHost

https://www.androidfilehost.com/?w=files&flid=322410

If you are clean flashing, checkout the Post-install section of the LineageOS for Microg front page

This build should dirty flash OK over earlier versions of LineageOS for Microg , and a quick test indicates it works OK over a non-Microg installation too.

Probably a good idea to backup your current setup before flashing it

 

[Berni-0815]

New version out; see 1st post.

• Android security patch level: 5 January 2022

 

[Berni-0815]

I have just made an up-to-date unofficial LineageOS for Microg build for suzuran based on Berni's ROM.

Is the source code for the necessary changes available?

 

[petefoth]

Is the source code for the necessary changes available?

Not sure what you mean. I built with the lineage4microg Docker file, and a manifest pointing to your repos. So I guess it will have the latest code from LOS and from you at the date I built it

 

[Berni-0815]

Since I'm not using docker and I'm not willing to use it, I like to know which changes are necessary for building a microG compatible ROM.
I know about this site, but I'm not sure if my work meets the requirements.

 

[Ermann123]

Since I'm not using docker and I'm not willing to use it, I like to know which changes are necessary for building a microG compatible ROM.
I know about this site, but I'm not sure if my work meets the requirements.

Berni, my latest ROM installatiion experience was rather smooth, with just installing Magisk -> Riru Module + Riru LSPosed (former Xposed) -> FakeGapps and then MicroG Installer Revived from Magisk. (the necessary signature spoofing was running fine from the beginning).

 

[Ermann123]

Berni, my latest ROM installatiion experience was rather smooth, with just installing Magisk -> Riru Module + Riru LSPosed (former Xposed) -> FakeGapps and then MicroG Installer Revived from Magisk. (the necessary signature spoofing was running fine from the beginning).

P.S. I was doing this on 18.1 now, but earlier before the same with 17.1

 

[Berni-0815]

the necessary signature spoofing was running fine from the beginning

Yes! I've somehow forgotten that signature spoofing is already included.
I've installed microG from their website successfully on my 19.0 build and it seems to work flawlessly; without any additional tools.

 

[petefoth]

Since I'm not using docker and I'm not willing to use it, I like to know which changes are necessary for building a microG compatible ROM.
I know about this site, but I'm not sure if my work meets the requirements.

No changes are required: it's a standard LineageOS build ,except
- Signature spoofing is implemented, set to 'restricted', so only apps that are part of the ROM can spoof
- The components from this repository included as pre-installed `system` apps.

And Docker isn't necessary. I build with a script (based on the /e/ OS dockerfile) adapted to build Lineage0S as well as / instead of /e/OS. That isn't necessary: you can just build however you normally build LineageOS, so long as you include the necessary additions in your manifests and build varaibles

 

[Berni-0815]

New version out; see 1st post.

• Android security patch level: 5 February 2022

 

[benh77]

For those of you that have issues with Bluetooth dropping continuously, I've found a solution. So far only tested with media player, but assume it will work for calls etc too. I needed to do this action once for each BT device, but then as I reconnect to the devices they are staying stable..

Settings > Developer Options > Bluethooth Audio Codec >> change to Use System Selection (Default)

In my case, the setting was AAC both before and after making the change, but resetting has clearly made a difference.

 

[benh77]

For those of you that have issues with Bluetooth dropping continuously, I've found a solution. So far only tested with media player, but assume it will work for calls etc too. I needed to do this action once for each BT device, but then as I reconnect to the devices they are staying stable..

Settings > Developer Options > Bluethooth Audio Codec >> change to Use System Selection (Default)

In my case, the setting was AAC both before and after making the change, but resetting has clearly made a difference.

Well after a few weeks, I can see that the above isn't working perfectly. I get more stability, but the bluetooth still drop its "Active" status. Seems to happen sometimes randomly, and sometimes when I move the phone (as if there is some kind of motion trigger?). It sometimes improves after doing the steps above, usually improves after charging and sometimes after a restart.

Is anyone else experiencing this? I love listening to music and the issues is frustrating. Not sure if it's just my phone.

 

[Berni-0815]

New version out; see 1st post.

• Android security patch level: 5 March 2022

 

[Berni-0815]

New version out; see 1st post.

• Android security patch level: 5 April 2022