Stuck in recovery mode npjs 25.93.14.8

[Mohitpahariya1]

Hello.

My mobile ver 25.93.14.4 is rooted and twrp is installed. Today I got update for my device which is npjs 25.93.14.8 I downloaded this update and after downloading i click on install button a message appears that phone will restart in 10 seconds after restarting the mobile stuck in recovery mode. I again try to restart but again automatically i log into recovery mode. what should I do to install new update.

Thanks in advance.

 

[echo92]

I think since you are rooted and you tried installing the OTA, the boot.img is replaced by the original one, that breaks the phone if flashed on root. so you can try 2 things:
1. Try flashing the EX kernel again. Flash the Uninstaller 1st and then flash it again and then normal boot from TWRP.. if it loops to TWRP, use point 2 procedure.. if it works...
2. If you are being re-directed to the TWRP. press and hold power + Vol down to go to bootloader and then use normal mode.

Personally, I would flash EX kernel again and then boot...

Hope it helps!

If Nothing helps..Make a Nandroid backup, Boot to bootloader by Power+Vol down. and then flash stock from PC..

u can restore the nandroid backup by Titanium Pro..

Try the steps that abhi212b suggested (this was for users that had TWRP installed and took the March OTA when it was available).

As an aside, OTA updates will only install properly on the stock recovery with a stock system and kernel. Thus you'll have to remove root, flash a stock kernel and stock recovery and then you should be able to install the OTA. If you have a custom logo.bin, you'll have to flash the stock logo.bin too.

 

[Mohitpahariya1]

Thanku so much.

 

[Madhav mad]

Try the steps that abhi212b suggested (this was for users that had TWRP installed and took the March OTA when it was available).

As an aside, OTA updates will only install properly on the stock recovery with a stock system and kernel. Thus you'll have to remove root, flash a stock kernel and stock recovery and then you should be able to install the OTA. If you have a custom logo.bin, you'll have to flash the stock logo.bin too.

Thank you so much buddy...
solved my problem:good: