[WIP] [4.4.4][CM 11]CyanogenMod 11[v0.19]

[digyvijaykumar123]

First Ever Kitkat For A110Q​

Original Thread​

#include 
/*
 * Your warranty is now void.
 *
 * I am not responsible for bricked devices, dead SD cards,
 * thermonuclear war, or you getting fired because the alarm app failed. Please
 * do some research if you have any concerns about features included in this ROM
 * before flashing it! YOU are choosing to make these modifications, and if
 * you point the finger at me for messing up your device, I will laugh at you.
 *
 * Submitting bug reports on nightly builds is the leading 
 * cause of male impotence.
 */

PHONES CAN BE LIVE SAVERS. THIS DEVICE IS NOT SUITABLE AS YOUR ONLY MEANS FOR COMMUNICATIONS AND IS NOT BEEN TESTED TO SUPPORT EMERGENCY CALLS. MAKE SURE YOU HAVE ANOTHER PHONE WITH YOU.

CyanogenMod

CyanogenMod is based on the Android Open Source Project with extra contributions from many people within the Android community. It can be used without any need to have any Google application installed.

SYSTEM PARTITION INCREASE NOT NEEDED
USE 6.0.5.1 KITKAT RECOVERY TO FLASH​

What works:​

• SIM1 for phone calls (incoming/outgoing) and SMS, data (2g, 3g)
• SIM2 is a WIP
• Audio (microphone - now also outside phone calls, loudspeaker, headphones, OK google)
• Sensors
• Wifi
• GPS (no A-GPS yet nor EPO assist files, so the fix can take a bit)
• hw composer
• camera for taking pictures (video from third party apps)
• wifi and usb tethering
• battery usage stats (expect the usage for Display to be very unprecise)
• bluetooth
• candy crush, facebook and twitter
• GPS

What doesn't work:​

• 2nd sim card 3G switch, Dual SIM is a WIP, not fully there yet
• USSD
• FM radio not available
• A-GPS does not work
• Video recording with Default camera.

Downloads & Changelog:
DOWNLOAD: CM11_V0.19.ZIP
DOWNLOAD:Gapps
CHANGE-LOG CM11_V0.19.zip:

• sync with CM
• enable CWM to install from cmupdater
• remove MTK audio policy and use default
• increase BT a2dp MTU (does it help?)
  

INSTRUCTIONS​

• Place the zip file in sdcard.
• Reboot to recovery (CWM)
• Make a backup with CWM - you will want to go back to stock, don't blame me if you don't have a backup!!!
• Wipe data/factory reset.
• Wipe dalvik Cache.
• Install CM-11_v0.19.zip
• Install Gapps[Flash 4.4.4 gapps]
• Reboot!

Older downloads & Changelog:

CM11 V0.17 :

CM11_v0.17.zip & DENSITY PATCH
Change-log:

• sync with CM
• First Attempt To Fix BT

CM11 V0.15 :

CM11_v0.15.zip
Change-log:

• sync with CM
• wifi: show mac address and allow country settings
• dualsim: incall knock-on fix and fix FDN back crash (all courtesy of @pawitp)

CM11 V0.14 :

CM11_v0.14.zip
Change-log:

• Sync with CM (Latest)
• Fixed some bugs like music player,audio,more stable,etcc...

CM11 V0.13 :

CM11_v0.13.zip
Change-log:

• Sync with CM (latest)

CM11 V0.12 :

CM11_v0.12.zip / STABILITY PATCH thanks to @Besik_13 (our Russian friend)
Change-log:

• Sync with CM (July 20)
• OK Google HotWord Detection.

CM11 V0.11 :

CM11_v0.11.zip
Change-log:

• Expose all internal storage location for mass storage USB
• USB OTG for external USB location
• (hw) video en/decoding enabled
• USSD
• Sync with CM (Close To M8)

CM 11 V0.9:

CM11_0.9.ZIP
Changelog:

• Torch (flashlight) enabled
• updated to latest CM (i.e. 4.4.4 as of June 28th)
• More Stable for Different HW versions Of A110Q by using 3 different kernels.

CM 11 V0.8:

DOWNLOADDropbox Mirror
Changelog:

• DualSIM fixes for some SIM cards (eg. UNINOR,AIRCEL). Dual SIM still has some stability issues.
• Fligthmode fixes (still not 100% there, but at least doesn't hang anymore)
• Approx. CM M7 (nightly from 15th of June)

CM 11 V 0.7

DOWNLOADWithConcept Xto BE flashed after rom flashing.
Changelog:

• Wifi Tether
• Better battery stats
• ffmpeg codecs
• kitkat 4.4.3 (sync'ed from CM)
• USB Tether works
• HTC Blinkfeed Added
• 100% CM themes supported
• Torch,flash,video recording,USB-PC interface,SWAP memory....

CM 11 V 0.6

DOWNLOAD
Changelog:

• camera takes pictures
• working hw composer
• enable dual sim by default
• sync with CM

CM 11 V 0.2

DOWNLOAD
Changelog CM 11 V0.2:

• microphone works now also for google now + voice recorder
• RIL enhancements: network IDs reported
• Update to latest CM source (27-April-2014)
• GPS works (without A-GPS not EPO helper files). The first fix takes quite a while.
• Latest Kash Kernel Included.

CM 11 V 0.1

DOWNLOAD
Changelog CM 11 V0.1:

• Initial Booting.

Credits:
@chrmhoffmann For Bringing First ever CM11 To Mediatek
@kashifmin For His First Ever Custom Kernel For A110Q.
@hyperion70
many thanks go to the omnirom project as they have done lots for mt6589 already (https://gerrit.omnirom.org/#/q/topic:mt6589,n,z). Esp to @xplodwild and @drshadow, @pawitp, @dhacker29


Sources:
Kernel: https://github.com/kashifmin/KashKernel_4.2
Device: https://github.com/chrmhoffmann/andr..._wiko_stairway
Android: https://gerrit.omnirom.org/#/q/topic:mt6589,n,z - more to come

XDA:DevDB Information
CM 11 4.4.4, ROM for the Micromax Canvas 2 Plus A110Q

Contributors
digyvijaykumar123, chrmhoffmann
ROM OS Version: 4.4.x KitKat
ROM Kernel: Linux 3.4.x
Based On: CyanogenMod

Version Information
Status: Beta
Current Beta Version: 0.19

Created 2014-03-30
Last Updated 2014-10-07

 

[digyvijaykumar123]

STUFFS

How To Use Different Kernels In CM 11 And Flash By Yourself (PC's Required):-
1)Download desired kernel for your device.
2)Now use 7zip to open it and drag its boot.img outside in any folder.Also drag and drop CM's boot.img in any other folder and name it so you dont forget.
3)Use unpack scripts or Kitchen to decompile CM boot.img and move the decompiled contents to a separate folder.
4)Now decompile your desired kernel's boot.img and replace its ramdisk with CM's ramdisk.
5)Now recompile it and drag the recompiled boot to kernel zip file via 7zip.
6)flash it....((^^^use CM's ramdisk and your desired kernel(zImage) and pack the and flash))

For Swapping Memory:-
Decompile Boot.img and under ramdisk you will find fstab.mt6589,open it via Notepad++ and make below changes to swap memory:-

# Android fstab file.
#<src> <mnt_point> <type> <mnt_flags and options> <fs_mgr_flags>
# The filesystem that contains the filesystem checker binary (typically /system) cannot
# specify MF_CHECK, and must come before any filesystems that do specify MF_CHECK

/[email protected] /system ext4 ro,noatime wait
/[email protected] /cache ext4 noatime,nosuid,nodev,noauto_da_alloc wait
/[email protected] /data ext4 noatime,nosuid,nodev,noauto_da_alloc wait,encryptable=footer

/devices/platform/mtk-msdc.0/mmc_host/mmc0 auto auto defaults voldmanaged=sdcard1:8,nonremovable,noemulatedsd
/devices/platform/mtk-msdc.1/mmc_host/mmc1 auto auto defaults voldmanaged=sdcard0:auto

/dev/bootimg /boot emmc defaults defaults
/dev/recovery /recovery emmc defaults defaults

KERNEL PATCHES & MEMORY SWAPP(V0.12 and Older only):-​

V0.11/V0.12

HYPER KERNEL:-THREAD(thanks to @hyperion70)

HYPER KERNEL CM11 V 0.11
HYPER KERNEL CM11 V 0.11 WITH MEMORY SWAPP

KERNEL SOURCES: https://github.com/hyperion70/iq451_mt6589

KASH KERNEL:-THREAD(thanks to @kashifmin)

KASH KERNEL CM11 V 0.9
KASH KERNEL CM11 V 0.11 WITH MEMORY SWAPP

KERNEL SOURCES: https://github.com/kashifmin/KashKernel_4.2

DARKY KERNEL:-THREAD(thanks to @[email protected])

DARKY KERNEL CM11 V 0.11
DARKY KERNEL CM11 V 0.11 WITH MEMORY SWAPP

KERNEL SOURCES: https://github.com/Manish123789/DARKY-KERNEL

V0.9(older)

HYPER KERNEL:-THREAD(thanks to @hyperion70)

HYPER KERNEL CM11 V 0.9
HYPER KERNEL CM11 V 0.9 WITH MEMORY SWAPP

KERNEL SOURCES: https://github.com/hyperion70/iq451_mt6589

KASH KERNEL:-THREAD(thanks to @kashifmin)

KASH KERNEL CM11 V 0.9
KASH KERNEL CM11 V 0.9 WITH MEMORY SWAPP(ALREADY ADDED IN ROM)

KERNEL SOURCES: https://github.com/kashifmin/KashKernel_4.2

DARKY KERNEL:-THREAD(thanks to @[email protected])

DARKY KERNEL CM11 V 0.9
DARKY KERNEL CM11 V 0.9 WITH MEMORY SWAPP

KERNEL SOURCES: https://github.com/Manish123789/DARKY-KERNEL

IF YOU CHANGE YOUR ROM TO JELLY BEAN ROM AFTER INSTALLING CM11 THEN YOU WILL FACE DEEP SLEEP BUG AND SENSOR BUG.FLASH THIS FILE TO FIX- CLICK HERE

TIPS-
:-Use 3g in First Sim to get better Network
:-Use Videocam illusionpro app from Playstore or anywhere to recored Videos
:-Use CyangogenMod Themes from Playstore or anywhere to Change Look of Your CM

------------------------------------------------------------------------------------------------------------------------------------------------------------------

 

[digyvijaykumar123]

Reserved

ENABLING MULTISIM:-[For Older Versions only,Latest one already included]

su
setprop persist.radio.multisim.config dsds

DISABLING MULTISIM

su
setprop persist.radio.multisim.config none

>>>>::ENTER CODES IN TERMINAL::<<<<

 

[pankycool123]

waiting for it.......... keep up the good work........

 

[vneogi199]

First ever kitkat. Hope most of all bugs can be solved though.

Sent from my C2305 using Tapatalk

 

[DevendraMilmile121]

waiting

Waiting plz upload fast

 

[rxlord]

i was wondering will we ever get a a110q cm without any bugs and with everthing working

 

[iashishyadav]

upload it! what u are waiting

when ARE YOU GOING TO UPLOAD it or u just make the thread when its not prepared to make the hype

 

[supersapien]

Bugs that I encounter will be posted here.

• Screen flickers after lock.

 

[digyvijaykumar123]

when ARE YOU GOING TO UPLOAD it or u just make the thread when its not prepared to make the hype

Guys, sources have been released recently. So lot of bugs need fixing. Patience is required.

Sorry For late in Uploading.I am using 2g Now so it took some time.Link is added.Enjoy.

 

[abhimanyu bajaj]

http://mxrootrom.blogspot.in/2014/02/mediatek-mtk-kernel-source-code-leaked.html

 

[digyvijaykumar123]

http://mxrootrom.blogspot.in/2014/02/mediatek-mtk-kernel-source-code-leaked.html

link is dead
edit:its working but its old content.

 

[abhimanyu bajaj]

link is dead
edit:its working but its old content.

well anyways
is there anyway the whole source will be released? and if it is... can you fix the bugs on CM?

 

[nagendhra.sudheer2]

Brother you said sim1 is working
But
I have tried both cm11 & omni roms
In both roms network is unavailable, manual network selection also failed
Please help me i want to use this Brother
Thank you

Sent from my Micromax A110Q using Tapatalk

 

[abhimanyu bajaj]

Brother you said sim1 is working
But
I have tried both cm11 & omni roms
In both roms network is unavailable, manual network selection also failed
Please help me i want to use this Brother
Thank you

Sent from my Micromax A110Q using Tapatalk

Check you imei number... is it still there
if not... then restore it

 

[nagendhra.sudheer2]

I have restored imei through mobile uncle mtk tools even though network is not working


Sent from my Micromax A110Q using Tapatalk

 

[digyvijaykumar123]

I have restored imei through mobile uncle mtk tools even though network is not working


Sent from my Micromax A110Q using Tapatalk

Check that your imei number is showing in settings/about phone...

 

[supersapien]

Any progress in development?

 

[digyvijaykumar123]

any progress in development?

yes but not major,this is a very time taking.it is not dead.but lots of time required for it.....

 

[rxlord]

I really wish we get a fully functional cm and what about kash kernel patch for miui

Sent from my A110Q using xda app-developers app